Pioneer A9 Manual de Instruções - Página 26
Procurar online ou descarregar pdf Manual de Instruções para Amplificador Pioneer A9. Pioneer A9 28 páginas. Non swithing amp
Também para Pioneer A9: Manual de Instruções (28 páginas), Manual de serviço (13 páginas), Manual de Instruções (16 páginas), Manual de serviço (5 páginas)
Imprimir página
07
Additional information
Problem
Can't operate the remote
control.
The display is dark or off.
XM radio messages
Message
ANTENNA
ANT ERR
UPDATING
NO SIGNAL
LOADING
OFF AIR
CH– – –
Specifications
Amplifier section
Power output specification is for when power
supply is 120 V.
•
Continuous power output (both channels
driven at 20 Hz to 20 kHz)**
THD 0.2 %, 4
THD 0.2 %, 8
26
En
Downloaded from
www.Manualslib.com
Remedy
• Replace the battery (refer to page 7).
• Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel
(refer to page 13).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DIMMER on the remote repeatedly to return to the default.
Cause
The XM antenna is not connected.
A short-circuit occurring in the antenna or
surrounding antenna cable.
The radio is being updated with the latest
encryption code.
The XM signal is too weak at the current
location.
The receiver is acquiring audio or program
information.
The channel currently selected has stopped
broadcasting.
You have selected a channel that does not
exist, or that you have not subscribed to.
There is no artist name/feature, song/
program title, or channel category associated
with the channel at this time.
Ω
. . . . . . . . . . . . . . . . . 70 W + 70 W
Ω
. . . . . . . . . . . . . . . . . 55 W + 55 W
manuals search engine
Action
Check that the XM antenna cable is attached
securely.
Make sure that there is nothing unusual with
the antenna or antenna cable. Switch the
power off then back on again.
Wait until the encryption code has been
updated. Channels 00 and 01 should function
normally.
n/a
Wait until the information has been received.
Select another channel.
The receiver will automatically switch to
channel 001 (or the last selected channel).
No action needed.
•
FTC Continuous power output (both
channels driven at 1 kHz)
Ω
THD 1.0 %, 4
. . . . . . . . . . . . . . . . . 65 W + 65 W
Ω
THD 1.0 %, 8
. . . . . . . . . . . . . . . . . 55 W + 55 W
•
Total harmonic distortion**
Ω
20 Hz to 20 kHz, 25 W, 8
* Measured with DIRECT button switched on.
** Measured by Audio Spectrum Analyzer
. . . . . . . . . . . . 0.05 %*