Pioneer Elite A-20 Manual de Instruções - Página 7

Procurar online ou descarregar pdf Manual de Instruções para Amplificador Pioneer Elite A-20. Pioneer Elite A-20 32 páginas. Owner's manual
Também para Pioneer Elite A-20: Manual de Instruções (32 páginas)

Imprimir página

1. Connecting Speaker Cables

Connecting up

Connecting speaker cables

Twist the cable cores.

Loosen the nut on the SPEAKERS

terminal, and insert the speaker cable into

the exposed hole in the terminal shaft.

Retighten the terminal nut.

10 mm

• If you want to use speaker cables terminated with

banana plugs, screw the speaker terminal fully

shut, then plug the banana plug into the end of the

speaker terminal.

Caution

• When using only one set of speaker terminals

(SPEAKERS A or SPEAKERS B), or when utilizing

bi-wiring connections, the speaker used should

have a nominal impedance between 4 Ω and

16 Ω. When using both sets of terminals, the

connected speakers should have nominal

impedance between 8 Ω and 32 Ω. Consult the

instructions accompanying your speakers for

details regarding the impedance value.

• Make sure the positive and negative (+/–) terminals

on the amplifier match those on the speakers.

• These speaker terminals carry HAZARDOUS live

voltage. To prevent the risk of electric shock when

connecting or disconnecting the speaker cables,

disconnect the power cord before touching any

uninsulated parts.

• Make sure that all the bare speaker wire is twisted

together and inserted fully into the speaker

terminal. If any of the bare speaker wire touches the

back panel it may cause the power to cut off as a

safety measure.

Connecting audio cables

Connect the white plug to the left (L) jack, and the red

plug to the right (R) jack. Be sure to insert the plugs fully

into the jacks.

Left (white)

Right (red)

Using centralized control with other

Pioneer components

Multiple Pioneer components equipped with CONTROL

IN/OUT jacks can be connected to the A-20 unit,

allowing centralized control of the components via the

remote sensor on the A-20. This also allows remote

control of components not equipped with a remote

sensor, or installed in places where the component's

remote sensor cannot be accessed.

OUT

To other Pioneer

CONTROL

component

equipped with

CONTROL IN jack

Other Pioneer

component equipped

with CONTROL IN/

OUT jacks

A-20

Aim remote control

A-20

remote

at the sensor on the

A-20.

control

Note

• For connections use a commercially available

monaural miniplug cord (without resistor).

• When connecting the CONTROL IN/OUT jacks,

commercially available audio cords must also be

used to make analog connections. Merely

connecting the CONTROL IN/OUT jacks alone will

not allow proper system control.

• When a control cord is connected to the A-20's

CONTROL IN jack, the unit cannot be controlled by

pointing the remote control at the A-20 (the remote

sensor is automatically disabled).

Plugging in

Important

• When going on a trip or otherwise not using the

unit for an extended period, always disconnect the

power cord from its outlet. Note that various

internal settings will not be lost even if the power

cord is disconnected from its outlet for an extended

time.

• If it is necessary to detach the power cord, first be

sure to press the /I STANDBY/ON button on the

front panel of the unit so the A-20 is turned OFF.

After you've finished making all connections, plug the

unit into an AC outlet.

This unit's rear panel

To AC outlet

Power cord

Plug the power cord into an AC outlet.