Pioneer Elite SX-A6-J Manual de Instruções - Página 14

Procurar online ou descarregar pdf Manual de Instruções para Amplificador Pioneer Elite SX-A6-J. Pioneer Elite SX-A6-J 24 páginas. Pioneer stereo receiver operating instructions
Também para Pioneer Elite SX-A6-J: Ficha de especificações (2 páginas)

Imprimir página

1. Specifications

Listening to your system

Chapter 4:

Listening to your system

Using Direct listening

Use the Direct listening feature when you want

to hear the truest possible reproduction of a

source. All unnecessary signal processing

bypassed, and you're left with the pure sound

source.

•

While listening to a source, press DIRECT

to switch Direct listening on or off.

Using the balance and tone

controls

Depending on what you are listening to, you

may want to adjust the bass, treble or left/right

balance using the remote control.

Press TONE/BAL to select the option you

want, then use the L/– and R/+ buttons to

adjust as necessary.

• BASS – Adjust the amount of bass from

–10 to +10.

• TRE – Adjust the amount of treble from

–10 to +10.

• BAL – Adjust the amount of left/right

balance as you like. FLAT indicates a

centered balance.

Wait about five seconds for your changes to be

input automatically. The BASS and TREBLE

indicators light in the front panel when the

corresponding tone control is active.

• To return to the flat setting (tone control

off), press L/– and R/+ at the same time.

Note

1 The balance and tone controls are disabled, and the front panel display switches off.

2 The receiver's volume, balance and tone controls have no effect on the recorded signal.

Playing other sources

Turn on the power of the playback

component.

Turn on the power of the receiver.

Select the source you want to playback.

Use the input select buttons (or INPUT

SELECTOR dial).

Start playback of the component you

selected in step 1.

Making an audio recording

You can make an audio recording from any

audio source connected to the receiver.

Select the source you want to record.

Use the input select buttons (INPUT

SELECTOR).

Prepare the source you want to record.

Tune to the radio station, load the CD, set up

the turntable, etc.

Prepare the recorder.

Insert a blank tape, MD, etc. into the recording

device and set the recording levels.

Refer to the instructions that came with the

recorder if you are unsure how to do this.

Start recording, then start playback of the

source component.