Pioneer KEH-P4000 Manual do Proprietário - Página 5
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador Pioneer KEH-P4000. Pioneer KEH-P4000 24 páginas. Multi-cd control fm/mw/lw tuner deck amplifier
Também para Pioneer KEH-P4000: Manual do Proprietário (27 páginas), Manual do Proprietário (48 páginas)
Imprimir página
Don't pass the orange lead through a
hole into the engine compartment to
connect to the battery. This will damage
the lead insulation can cause a very dan-
gerous short.
Do not shorten any leads. If you do, the
protection circuit may fail to work when
it should.
Never feed power to other equipment by
cutting the insulation of the power sup-
ply lead of the unit and tapping into the
lead. The current capacity of the lead
will be exceeded, causing over heating.
When replacing fuses, be sure to use
only fuse of the rating prescribed on the
fuses holder.
Since a unique BPTL circuit is employed,
never wire so the speaker leads are di-
rectly grounded or the left and right
speaker © leads are common.
Speaker connected to this unit must be
high-power types possessing minimum
rating of 22 W and impedance of 4 to 8
ohms. Connecting speakers with output
and/or impedance values other than those
noted here can damage the speakers.
When the power amp is being linked
with this system, be sure not to connect
the blue lead to the amp's power termi-
nal. Likewise, when linking this system
with the auto-antenna, do not connect to
power terminal for the antenna. Such
connection can make overcurrent cause
malfunctions.
To prevent incorrect connection, the in-
put side of the IP-BUS connector is blue,
and the output side is black. Connect the
connectors of the same colors correctly.
When the unit is mounted in a vehicle
whose ignition switch does not have the
ACC (accessory) position as shown in Fig.
6, be sure to connect the red lead of the
unit to the terminal controlled by the igni-
tion switch ON/OFF position. If you do
not, the vehicle battery may go flat when
you leave your vehicle for several hours.
ACC position
No ACC position
Fig. 5
Fig. 6