Pioneer SA-1040 Manual de Instruções - Página 10

Procurar online ou descarregar pdf Manual de Instruções para Amplificador Pioneer SA-1040. Pioneer SA-1040 13 páginas.
Também para Pioneer SA-1040: Manual de serviço (22 páginas)

Imprimir página

TROUBLESHOOTING

If you think that something has gone wrong with your unit, check out the points below before calling in the ser-

viceman.

The cause of the trouble may lie in improper maintenance or operation. If the trouble is still not remedied even

after the checks have been carried out, contact your nearest PIONEER service center.

Trouble

Possible cause

Remedy

No sound from

speakers.

No sound from one

speaker.

No broadcast

reception.

No record play heard.

No recording.

POWER

switch at OFF.

Disconnected power cord.

. Minimum volume level.

. Connecting cord has become

disconnected from input terminal.

. Speaker cord has become

disconnected

from output terminal.

. ADAPTOR/TAPE 2 switch at ON.

. Both A and B SPEAKERS

SWITCHES

have been depressed although two pairs

of speaker systems, A and B, have not

been connected.

. BALANCE control at leftmost or

rightmost position.

. One of speaker cords has become

disconnected.

Disconnected antenna connecting cord.

. Antenna direction and height noi

adjusted properly.

. Station not tuned in properly.

. Tonearm is still in raised position.

. Stylus not in position.

. TAPE 1 function switch has been pushed.

. Cassette tape's accidental erasure

prevention tab broken out.

Disconnected connecting cord.

. Set switch to ON.

Plug into power outlet properly.

Rotate VOLUME

control clockwise.

. Connect pin plug securely.

. Connect speaker cord properly.

. Set switch to OFF.

Release

the

SPEAKER

SWITCH

cor-

responding to the rear panel SPEAKERS

terminals which have not been connected

to a speaker system.

. Set control to center position.

. Connect cord securely.

. Connect antenna cord to terminal

properly.

Install antenna in proper direction and at

proper height.

Refer to Operating Instructions of tuner.

. Operate arm and play record.

Insert stylus properly.

Press function switch

corresponding

program source which is to be recorded.

Replace cassette tape or adhere piece of

cellophane tape over opening where tab

was broken out.

. Connect cord properly.

(Refer to CONNECTION

DIAGRAM

POWER

CORD CONNECTION

on pages

4 and 5.)