Pioneer SA-6700 Manual de Instruções - Página 45
Procurar online ou descarregar pdf Manual de Instruções para Amplificador Pioneer SA-6700. Pioneer SA-6700 48 páginas. Stereo cd cassette deck receiver, speaker system
Também para Pioneer SA-6700: Manual de serviço (44 páginas)
Imprimir página
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the
points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry
out repair work.
Symptom
No sound from speakers.
Cassette door does not
open.
Cannot record.
Sound is muffled.
Previously recorded sounds
remain.
Sound overly bright. Treble
tones too strong.
The Music Search (MS)
does not work.
(XR-A670 only)
Playback does not start.
Sound is distorted.
There is no stereo sound.
Timer does not work.
Remote control does not
work.
Abnormal functioning of this unit may be caused by static electricity or other external interference. To restore normal operation, turn the power off
and then on again, or unplug the AC power cord and then plug it in again.
Cause
÷ AC cord is unplugged.
÷ Cords are not connected properly.
÷ Function is not set to the proper listening
source on the receiver.
÷ Power cord has been unplugged while the
tape was running.
÷ Broken erasure prevention tabs.
÷ Dirty heads.
÷ Tape recorded with DOLBY NR but played
without.
÷ The blank interval between two songs is
shorter than 4 seconds.
÷ The fast forward or rewind operation has
been started from stop mode.
÷ Disc is loaded upside down.
÷ Dirt, smear, etc. on the disc.
÷ Disc is warped or has a bad scratch.
÷ Antenna is not connected.
÷ Antenna is in poor position.
÷ Interference from nearby fluorescent light,
hair dryer, or other electrical appliance.
÷ The MONO indicator in the display window
on the receiver is lit.
÷ Current time is not set.
÷ Batteries are dead.
÷ A fluorescent light is shining on the remote
sensor window.
Remedy
÷ Plug power cord into wall socket correctly.
÷ Connect cords correctly referring to CONNECTIONS
P. 6
P. 7
on
.
÷ Select correct function.
÷ Plug in the power cord.
÷ Use a cassette that can be recorded on, or apply
adhesive tape over the tab holes.
÷ Clean heads (refer to
P. 38
÷ Turn on DOLBY NR system for tapes recorded with
DOLBY NR.( XR-A670 only )
÷ When playing tapes on the XR-A370 recorded using
another component's Dolby NR function, reduce
treble with the Sound Morphing function.
÷ Change
to
a tape having at least 4-seconds blank
interval between two songs.
÷ First put the tape deck in play mode then press the
fast forward or rewind button.
÷ Load a disc correctly with the label side (printed
side) UP.
÷ Clean the disc (refer to
P. 37
÷ Replace the disc (refer to
P. 37
÷ Connect the antenna correctly.
÷ Change the antenna position.
÷ Stop using device causing interference
(refer to
).
P. 9
÷ Press MONO so that the MONO indicator goes out
(refer to
).
P. 15
÷ Set current time.
÷ Replace with new batteries.
÷ Move the unit away from the fluorescent light (refer
to
).
P. 5
).
).
).
45
En/Fr
En