Pioneer SA-7800 Manual de Instruções - Página 4
Procurar online ou descarregar pdf Manual de Instruções para Amplificador Pioneer SA-7800. Pioneer SA-7800 12 páginas.
Também para Pioneer SA-7800: Manual de serviço (30 páginas)
Imprimir página
REAR
PANEL
FACILITIES
A Tscioe
|
oS
B BOG
i)
=
i]
SA-7800/S, S/G model
@
PHONO INTERFERENCE
FILTER SWITCH
This is used to attenuate radio-frequency inter-
ference
from
external
electronic
or
electrical
appliances or products during record play.
@
PHONO
JACKS
Connect
the turntable
output
cords to these
jacks.
@® GND TERMINAL
This is the ground terminal. Connect the ground
wire of the turntable, etc. to this terminal.
@ TUNER JACKS
Connect the tuner cords to these jacks.
() AUX JACKS
These are auxiliary input jacks. Connect
a TV
tuner or cartridge tape player to them.
© SPEAKERS TERMINALS A
Connect
your first pair of speakers to these ter-
minals.
@
SPEAKERS TERMINALS B
Connect
your second pair of speakers to these
terminals.
TAPE 1 JACKS
Connect
the tape
deck
cords to these jacks.
Connect the REC (recording) jacks to the INPUT
jacks on the tape deck, and the PLAY (playback)
jacks to the OUTPUT jacks.
@) TAPE 2 JACKS
Connect
your
second
tape deck
cords to these
jacks. Connect the REC (recording) jacks to the
INPUT
jacks on the tape deck, and the PLAY
(playback) jacks to the OUTPUT jacks.
4
@ 9 9 @
B Bolas
ae
ee |]
SA-7800/HG model
AC OUTLETS (S, S/G models only)
These are spare power outlets. Insert the power
plug on the stereo components (turntable, tuner,
tape deck, etc.) into these outlets.
SWITCHED:
The power supplied through these
outlets is coupled to the operation of the
amplifier's
power
switch.
The
maximum
power capacity which may be connected to
the two SWITCHED
outlets is 200W.
UNSWITCHED:
The
power is always supplied
through these two outlets regardless of the
position of the power switch. The maximum
power capacity which may be connected to
these two outlets is 200W.
NOTES:
e
Never connect an iron or a toaster to these outlets.
e
Do
not get the power
outlets and
the power
plugs
wet or touch them with wet hands, since you may get
an electric shock.
() TAPE
2 JACK
(HG model only)
Connect the tape deck to this jack with DIN-type
(recording/playback) cord.
(2 LINE VOLTAGE SELECTOR SWITCH
Check that the indication of the switch is same as
your residence before plugging the power cord
into the outlet. If it isn't or if you move to an
area
where
the
voltage
requirements
differ,
change the switch setting as follows.
Before adjusting, disconnect the power cord.
ee model (220V/240V switchable)
1 . Loosen the screw
on the plug with a Phillips
screwdriver, then take out the plug.
2. Re-install
the plug with its cutaway section
exposing
the
correct
voltage
indication
as
shown in Fig. A.
3. Tighten the mounting screw.