Pioneer CMX-3000 Manual de Instruções - Página 33

Procurar online ou descarregar pdf Manual de Instruções para Leitor de CD Pioneer CMX-3000. Pioneer CMX-3000 33 páginas. Owner's manual
Também para Pioneer CMX-3000: Manual de Instruções (20 páginas)

Imprimir página

÷ There may be times when the CMX-3000 fails to operate properly as a result of static electricity or some other form of interference from an outside

source. If any such problem occurs, turn off the power to the CMX-3000, wait for the currently inserted disc to come to a full stop, and then turn on

the power again to see if that fixes the problem in question.

÷ The CMX-3000 cannot be used to replay partially-written CD-R or CD-RW discs.

÷ The CMX-3000 cannot be used to replay non-standard-shaped discs or any discs other than 5 inch/12 cm discs or 3 inch/8 cm discs which have

been inserted into an 3 inch/8 cm disc adapter. (Note that attempting to replay such discs may result in damage or breakdown.)

÷ The BPM value measured by the CMX-3000 may differ from the BPM value recorded on a CD or from our DJ mixer, but this difference is a result

of differences in the BPM value measurement method; not a result of a fault with the player.

Error Message Display

When the CMX-3000 CD player is unable to operate properly, an error code is displayed on the display panel. Check the error code

displayed against the following table and take the recommended action to correct the error. If an error code other than any of the error

codes listed in the table below is displayed or if the same error code is displayed even after corrective action has been taken, contact

your nearest Pioneer Service Station or contact the store from which you purchased your player for assistance.

Error Code

Error Type

E-72 01

TOC READ ERROR

E-83 01

PLAYER ERROR

E-83 02

E-83 03

E-91 01

MECHANICAL TIME OUT

Cleaning the Jog Dial

To clean the PLAYER wipe with a polishing or a soft, dry cloth. For

stubborn dirt, moisten a soft cloth with a weak solution of neutral

detergent (diluted in five to six parts water), wring the cloth well, and

wipe away the dirt. Use a dry cloth to wipe the surface dry. Applying

alcohol, paint thinner, benzene, insecticides, or other stringent

substances to the jog dial may cause the markings or finishing of the dial

to peel or become discolored, and the use of any such substances

should accordingly be avoided.

Description

Player unable to read TOC data.

Player unable to play back currently

inserted disc.

Mechanical operation has failed to

complete within specified time interval.

Possible cause and recommended action

Disc is cracked.

= Recommended action: replace disc.

Disc is soiled or dirty.

= Recommended action: clean disc.

If other discs play normally, the problem is with the

disc itself.

Dust or some other form of foreign particles have

found their way into disc insertion slot.

= Recommended action: remove dust or other

foreign particles.

Published by Pioneer Corporation.

Appendix

Troubleshooting

En/Sp