Ariston AWD 121 Manual de instruções de instalação e utilização - Página 15
Procurar online ou descarregar pdf Manual de instruções de instalação e utilização para Máquina de lavar roupa Ariston AWD 121. Ariston AWD 121 17 páginas. Washer / washer-dryer combo
Também para Ariston AWD 121: Instruções para o utilizador (21 páginas), Manual de reparação (20 páginas)
Imprimir página
The washer-dryer
does not drain or
spin.
Does the selected program
incorporate water drai-
ning? Some programs stop
at the end of the wash cycle
and draining will have to be
selected manually.
Is the "Easy iron" function
-where provided - enabled?
This
function
requires
manual
selection
draining.
Is the drain pump clogged?
To check it, turn off the water
supply, unplug the washer-
dryer
and
follow
instructions on page 18, or
call technical support.
Always get
assistance from
authorized service
agent and always
insist on original
spare parts.
Cleaning Filters
Remove filters
using tweezers,
clean and replace
Drain: to avoid flooding
be careful to the adjust the drain
hose to at least
25" above the base
of the appliance.
Fasten the hoses securely.
www.aristonappliances.us
Is the drain hose kinked?
The drain hose must be as
straight as possible. Make
sure the drain hose is not
crimped or kinked.
Is the washer-dryer's drain
hose clogged? Is there an
extension of the drain hose?
If so, is it positioned
incorrectly, blocking the
water flow?
for
Excessive vibration
during the spin cycle.
the
Have all shipping bolts
been removed during
installation?
following
page
installation procedures.
Has the washer-dryer been
levelled correctly? The
levelling of the appliance
should
be
periodically. Adjust the feet
and check them with a level.
Remove
filters, clean
and replace
Tape
Is there space between the
machine and adjacent
units? If it is not a built-in
model, the washer-dryer will
oscillate a bit during the spin
cycle. A few cm of space
should therefore be left
around it.
The washer-dryer
leaks.
Is the metal ring of the inlet
hose properly attached?
Turn off the water supply,
unplug the appliance and try
tightening its attachment
without forcing it.
See
the
Is the detergent dispenser
on
obstructed? Remove and
wash it under tap water.
Is the drain hose well
attached? Turn off the water
supply,
checked
appliance and try tightening
its attachment.
Tape
Too much foam.
Is the detergent appropriate
for machine washing? Check
whether the definition on its
label reads "for machine wash"
or "hand and machine wash",
or any other similar wording.
Is the correct amount being
used? An excessive amount of
detergent, besides producing
too much foam, does not
guarantee a more effective
wash, and causes scaling in the
internal parts of the appliance.
The washer-dryer
does not dry.
Check whether:
the plug has been correctly
inserted into the socket; there
is electricity in your home; the
appliance door has been shut
properly; a delayed start (if
available) has not been
unplug
the
selected; program knob A
has been set to Reset and
the drying cycle knob C has
been
0 minutes.
The washer-dryer doesn't
dry properly.
Check whether:
1) the end of the drain hose
is underwater; 2) the drain
pump is obstructed; 3) the
advice given on the maxi-
mum loads has been taken;
4) the water tap has been
turned on.
If, despite all checks, the
washer-dryer fails to function
and the problem persists, call
your
nearest
Customer Service Centre,
1-800-426-0825 providing the
following information:
Tape
- the nature of malfunction
- the model type no. (Mod. ....)
- the serial number (S/N ....)
This information can be found
on the data plate situated at the
back of the washer-dryer.
Instructions for installation and use
set
to
position
authorized
17