Pioneer AVX-P7300DVD Manual de instalação - Página 3
Procurar online ou descarregar pdf Manual de instalação para Leitor de DVD Pioneer AVX-P7300DVD. Pioneer AVX-P7300DVD 9 páginas. Pioneer avx-p7300dvd: install guide
Imprimir página
Installation
Note:
• Before finally installing the unit, connect the
• If installation angle exceeds 30° from horizontal,
wiring temporarily, making sure it is all connected
the unit might not give its optimum performance.
up properly, and the unit and the system work
(Fig. 6)
properly.
• Use only the parts included with the unit to ensure
proper installation. The use of unauthorized parts
can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifications
of the vehicle.
30°
• Install the unit where it does not get in the driver's
way and cannot injure the passenger if there is a
sudden stop, like an emergency stop.
• Do not place the display in a position where it will
impede the driver's visibility or affect the opera-
tion of your vehicle's air bags.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere hot
— for instance, near a heater outlet.
DIN Front/Rear-mount
This unit can be properly installed either from "Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit
chassis). For details, refer to the following illustrated installation methods.
DIN Front-mount
Installation with the rubber bush
1. Remove the frame. (Fig. 7)
Frame
Pull out to remove the frame.
(When reattaching the frame, point the
side with a groove downwards and
attach it.)
2. Install side brackets. (Fig. 8)
Flush surface screw (5 × 6 mm)
Fig. 6
3. Fastening the unit. (Fig. 9)
As a rule, secure with side brackets (large).
Holder
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
Dashboard
board material and bend them.
(Install as firmly as possible using the
182
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
53
Rubber bush
Screw
Side bracket
(large)
Fig. 7
7 When the installation space is not very deep
When installing in a shallow space, secure with side brackets (small). In this case, stick con-
ceal tape on parts that protrude from the dashboard.
Side bracket
Dashboard
182
53
Fig. 8
Attach screw
Fig. 9
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 11)
Holder
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
Rubber bush
Screw
Conceal tape
Attach screw
Side bracket
(small)
Fig. 10
<ENGLISH>
Frame
Pull out to remove the frame.
(When reattaching the frame, point the
side with a groove downwards and
attach it.)
Fig. 11