Pioneer CP-VSL3 Instruções de instalação e utilização - Página 7

Procurar online ou descarregar pdf Instruções de instalação e utilização para Sistema de altifalantes Pioneer CP-VSL3. Pioneer CP-VSL3 20 páginas. Hung on wall unit

Imprimir página

Assembly and Installation

Remove base

Using the provided Allen wrench, remove the three base

screws and then the base from the speaker. Save these

screws and the base if there is any chance you will want to

replace the bases for ordinary floor installations in the

future.

Attach upper plate

Using the furnished 3 mm Allen wrench, remove the four

screws from the top of the speaker. Place the upper plate

on the speaker top and use the 3 mm Allen wrench to

tighten the removed mounting screws.

Since the hex holes in the mounting screws are rather

shallow, be sure to hold the Allen wrench securely to

prevent slipping, and tighten the screws securely to

prevent slipping.

Fasten the safety strap to the speaker

Temporarily remove the mounting fixture on the rear of the

speaker, place around the safety strap and once again

fasten the mounting fixture to the speaker.

Safety strap

Temporary mounting

When the mounting fixture is combined with the

speaker system S-VSL3, the total weight is about

10 kg. The installation technician should decide

NOTE

on the optimum mounting method based on an

assessment of the wall's materials and

structure.

• Confirm the height from the floor. Enough space

must be left between the floor surface and the

speaker body to allow the introduction of a

screwdriver in order to install and tighten the

terminal cover.

Hole for temporary

mounting (φ 5.5)

Consult the dimensional

diagram on P. 9 for

external dimensions

following speaker

installation.

Mark the position of the mounting screws

Use a level or plumb bob to confirm the perpendicular,

and mark the position of the mounting screws on the wall.

The mounting screws should have a diameter of 4-5 mm (5

mm is recommended) in 6-8 locations. The safety strap

location and mounting screw diameters should be 1

screw of 5-6 mm in the upper square hole (6 mm is

recommended); bushing location and screw diameters

are 2 screws of 5-6 mm (6 mm recommended) within the

9x15 rectangular hole.

Floor