Pioneer AVD-W9000 Manual do Proprietário - Página 14

Procurar online ou descarregar pdf Manual do Proprietário para Monitor Pioneer AVD-W9000. Pioneer AVD-W9000 44 páginas. 9 inch wide xga display

Section

Connection and

installation

Connections

Important

! When this unit is installed in a vehicle without

ACC (accessory) position on the ignition

switch, red cable must be wired to the term-

inal that can detect the operation of the igni-

tion key. Otherwise, battery drain may result.

ACC position

! Use of this unit in conditions other than the

following could result in fire or malfunction.

— Vehicles with a 12-volt battery and negative

grounding.

! To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

— Disconnect the negative terminal of the

battery before installation.

— Secure the wiring with cable clamps or ad-

hesive tape. To protect the wiring, wrap ad-

hesive tape around them where they lie

against metal parts.

— Place all cables away from moving parts,

such as gear shift and seat rails.

— Place all cables away from hot places,

such as near the heater outlet.

— Do not pass the yellow cable through a

hole into the engine compartment to con-

nect to a battery.

— Cover any disconnected cable connectors

with insulating tape.

— Do not shorten any cables.

— Never cut the insulation of the power cable

of this unit in order to share the power

with other devices. Current capacity of the

cable is limited.

— Use a fuse of the rating prescribed.

No ACC position