Pioneer PDP-501MX Manual de serviço de campo - Página 18

Procurar online ou descarregar pdf Manual de serviço de campo para Monitor Pioneer PDP-501MX. Pioneer PDP-501MX 31 páginas.

Symptom: Set goes in to "power Down" mode within 1 or 2 seconds after turning on.

Cure: Unplug connector P6 from the power supply assy and power up again. If the unit stays on longer, quickly turn off

the unit to prevent further damage. Replace X Drive A and X Drive B. If there is no change after removing P6, replace

the connector and remove P7. It the unit stays on longer, quickly turn it off. The problem is on the "A" side. Further

troubleshooting will be needed to determine where the problem is (Y Drive A, Y drive B, or scan modules). DO NOT USE

THIS METHOD IF THE UNIT STAYS ON LONGER THAN 2 SECONDS TO BEGIN WITH.

Models Covered: PDPV401, PDPV402

Tip Date: July 10 2000

The Tech Name: Jeff Andrews

Symptom: Remote control commands will not pass through the PDPV402 to the PDA4003 down-converter.

Cure: You must use a VGA cable between the plasma and the down -converter that has all 15 pins wired.

Models Covered: PDA4003, PDPV402

Tip Date: February 01 2000

The Tech Name: Bernie Shelton

Symptom: When a XDRIVE A or XDRIVE B is found to be bad.

Cure: Replace both A and B together.

Models Covered: PDPV400, PDPV401

Tip Date: October 26 1999

The Tech Name: Dennis Walden

Symptom: Intermittent no video after turning set off & on.

Cure: The plasma set should be turned on BEFORE the video source.

Models Covered: PDPV400, PDPV401, PDPV402

Tip Date: February 08 1999

The Tech Name: Bernie Shelton

Back to Search

You use this information AT YOUR OWN RISK and are utterly responsible for you own actions and this information is

provided AS-IS! By viewing, printing, or downloading this information, you agree to hold Pioneer Electronics Service,

Inc. and it's employees harmless and without liability and without exception.