Dinel CLS-23 Manual de instruções - Página 8

Procurar online ou descarregar pdf Manual de instruções para Acessórios Dinel CLS-23. Dinel CLS-23 18 páginas. Capacitive level sesors
Também para Dinel CLS-23: Manual (20 páginas)

Imprimir página

or electrodes with a length over 300 mm for the detection in nonconductive containers sensors

in vertical position must be used the auiliary electrode e.g. conductivity probe. The auxiliary

electrode is connected to the sensor housing. Recommended length of the auiliary electrode

and the distance from the sensor are shown in the picture.

uitable types of auiliary electrode probes are e.g. inel  with  thread.

Fig. 6: Auxiliary electrode in non-conductive tanks

7 . e

lectrical connection

or  variant with the ed cable the individual colour cores of the connecting cable are con-

nected to the respective terminals of the related euipment supply unit.

or  variant with the connector the cable can be supplied with the sensor length  or  m tted

with the pressed connector socet or dismountable connector socet without the cable see acces-

sories. n this case the cable is connected to the inside pins of the socet according to ig. .

The sensor with related euipment is interconnected by a suitable threecore  variation or two

core  and R variations cable. The length of the cable for the i and iT variations must be

selected with respect to the maimum permitted parameters usually inductance and capacity of

the outside intrinsically safe circuit of supply units   . f using a dismountable

connector socet the outside diameter of the cable is a maimum of  mm

Sensors CLS 23 are equipped with protection against over-voltages and current overload. The capacity

loads and low resistance (bulb) are evaluated by sensors with output type P and S as short circuit.

Sensors with output type R are designed for interconnect to intrinsically safe supply units.

In case of strong ambient electromagnetic interference, paralleling of conductors with power distribu-

tion, or for the distribution to distance over 30 m, we recommend to use shielded cable.

 Dinel

CLS 23

Auxiliary electrode PDE 18

Electrical connection to

the sensor housing

Applies to: CLS 23_ 20, 21, 30 (for electrode length up to 300 mm)

Conductive probe

CNP 18F 30

Non-conductive tank

Ep >

E Electrode length in mm

≈