Aeotec Doorbell 6 Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Acessórios Aeotec Doorbell 6. Aeotec Doorbell 6 7 páginas.
Também para Aeotec Doorbell 6: Manual do utilizador (3 páginas)
Imprimir página
sided tape. b. Lock your Button onto the mounting plate.
Pairing your Doorbell 6 into your existing Z-Wave network.
1. Power Doorbell 6 through the provided power adapter.
2. Ensure that Doorbell 6 LED is blinking slowly.
3. Set your Z-Wave gateway into pair / add device mode. (Refer to your Z-Wave gateway/controller instruction manual
on how to set it into pair mode).
4. Tap the Doorbell 6 Action Button once. (If your gateway supports S2 encryption, enter the first 5 digits of the DSK
into your Z-Wave gateway interface to complete S2 encrypted pairing, DSK is printed on the Doorbell 6 unit).
5. If Doorbell 6 has successfully paired to your Z-Wave gateway, the LED on Doorbell 6 will emit a solid color for 30
seconds, then turn off. If in the case that the Doorbell 6 failed to pair, LED will continue to blink slowly.
With your Doorbell now working as a part of your smart home, you'll be able to configure it from your home control
software. Please refer to your software's user guide for precise instructions on configuring Doorbell to your needs.
Advanced.
Removing your Doorbell from a Z-Wave network.
Your Doorbell can be removed from your Z-Wave network at any time. It is always advised that you use your gateway
to perform an unpair in order to avoid leaving phantom / failed nodes that become difficult to remove. To do so, follow
the steps below:
1. Place your gateway or controller into Z-Wave unpair or exclusion mode. (Please refer to your controller/gateway
manual on how to do this)
2. Press the Action Button 6x times in 2 seconds on your Doorbell.
3. If your Doorbell has been successfully unpaired from your network, its LED will begin to blink slowly which indicates
that it is ready to be paired again.
Test Doorbell 6 sound manually.