Aeotec Water Sensor 7 Pro Manual do utilizador - Página 6

Procurar online ou descarregar pdf Manual do utilizador para Acessórios Aeotec Water Sensor 7 Pro. Aeotec Water Sensor 7 Pro 9 páginas. Water sensor
Também para Aeotec Water Sensor 7 Pro: Manual (3 páginas), Manual de início rápido (8 páginas), Manual do utilizador (13 páginas), Manual do utilizador (14 páginas), Manual do utilizador (9 páginas)

Remove your Water Sensor 7 from Z-Wave network.

Your sensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main

controller/gateway. To do this, please refer to the part of your gateways respective manual that tells you how to remove

devices from your network.

1. Set your Z-Wave controller into unpair mode.

2. Triple-click the tamper switch on Water Sensor 7 within 1.5 seconds - this will cause the LED to blink five times.

3. After a successful exclusion, it will light up its LED for 2 seconds then deactivate.

Reset your Water Sensor 7.

This device also allows being reset without any involvement of a Z-Wave controller. This procedure should only be used

when the primary controller is inoperable.

To manually factory reset:

1. Remove the cover of Water Sensor 7

2. Press and hold tamper switch for 5 seconds until the red LED blinks.

3. Release the tamper switch

4. Immediately press and hold the tamper switch for 5 seconds until the red LED blinks.

Association Groups

Group Association allows Water Sensor to directly communicate with other Z-Wave devices directly without the need for

the Z-Wave Controller to act as a inbetween controller. This using this function will help with communication effeciency

and limit the amount of time it takes to control a device.

Group

Maximum

Number

Nodes

3. Visual LED indications

Description

Lifeline

Control devices when water leakage is detected

Sends out alarm message when water leakage is

detected

Sends alarm messages when tamper is tripped