Ariston FH 52 Manual de Instruções - Página 3

Procurar online ou descarregar pdf Manual de Instruções para Forno Ariston FH 52. Ariston FH 52 48 páginas. Ariston fh 52; fh 52 ix ovens

Imprimir página

Electrical connections

! Ovens equipped with a three-pole power supply

cable are designed to operate with alternating

current at the voltage and frequency indicated on

the data plate located on the appliance ( see below ).

Fitting the power supply cable

marked

( see diagram ).

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the

load indicated on the data plate ( see side ).

The appliance must be directly connected to the

mains using an omnipolar circuit-breaker with a

minimum contact opening of 3 mm installed between

the appliance and the mains, suitable for the load

indicated and complying with current electrical

regulations (the earthing wire must not be interrupted

by the circuit-breaker). The supply cable must not

come into contact with surfaces with temperatures

higher than 50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before connecting to the power supply, make sure that:

• The appliance is earthed and the plug is

compliant with the law.

1. Open the terminal

board by inserting a

screwdriver into the

side tabs of the cover.

Use the screwdriver as

a lever by pushing it

down to open the cover

( see diagram ).

2. Install the power

supply cable by

loosening the cable

clamp screw and the

three wire contact

screws L-N-

Connect the wires to

the corresponding

terminals: the Blue wire

to the terminal marked

(N), the Brown wire to

the terminal marked (L)

and the Yellow/Green

wire to the terminal

• The socket can withstand the maximum power of

the appliance, which is indicated on the data

plate ( see below ).

• The voltage must be in the range between the

values indicated on the data plate ( see below ).

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it.

Do not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be

easily accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only ( see Assistance ).

! The manufacturer declines any liability should

these safety measures not be observed.

DATA PLATE

width cm 43.5

Dimensions

height cm 32

depth cm 41,5

Volume

lt. 58

voltage: 220-240V ~ 50/60Hz o 50Hz

Electrical

(see data plate) maximum power

connections

absorbed 2250W

Directive 2002/40/EC on the label of

electric ovens Norm EN 50304

Energy consumption for Natural

convection heating mode:

ENERGY LABEL

a Convection

Declared energy consumption for

Forced convection Class

heating mode: b Fan assisted

This appliance conforms to the

following European Economic

Community directives:

- 2006/95/EEC of 12/12/06 (Low

Voltage) and subsequent

amendments;

- 2004/108/EEC of 15/12/04

(Electromagnetic Compatibility) and

subsequent amendments;

- 93/68/EEC of 22/07/93 and

subsequent amendments.

- 2002/96/EC and subsequent

amendments.