Aeotec AEOEZW116 Manual - Página 8

Procurar online ou descarregar pdf Manual para Instrumentos de medição Aeotec AEOEZW116. Aeotec AEOEZW116 16 páginas. Single nano switch with measuring
Também para Aeotec AEOEZW116: Manual de início rápido (11 páginas)

Imprimir página
Aeotec AEOEZW116 Manual
device, the controlling device needs to maintain a list of devices that will receive controlling commands. These lists
related to certain events (e.g. button pressed, sensor triggers, ...). In case the event happens all devices stored in t
same wireless command wireless command, typically a 'Basic Set' Command.
Association Groups:
Group Number
1
2
3
4
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the f
enhanced features.
IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 ... 255 t
value minus 256. For example: To set a parameter to 200 it may be needed to set a value of 200 minus 256 = minu
applies: Values greater than 32768 may needed to be given as negative values too.
Parameter 3: Current Overload Protection.
Over current protection. Output load will be closed after 30 seconds if the current exceeds (US: 15.5A, AU or EU: 1
Size: 1 Byte, Default Value: 1
Setting
0
1
Parameter 4: Overheat protection.
Output Load will be turned off automatically after 30 seconds and if the temperature of product inside exceeds 100°
Size: 1 Byte, Default Value: 0
Setting
0
1
Parameter 20: Configure the output status after re-power on it.
Configure the output status after re-power on it.
Size: 1 Byte, Default Value: 0
http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW116
Maximum
Description
Nodes
5
Z-Wave Plus Lifeline.When the load state of Nano S
Multilevel Report and Basic Report (configured by p
in this group.
Forward the Basic Set, Switch All, Scene Activation
5
Nano Switch receives the Basic Set, Switch All, Sce
5
Send Basic Set (configured by parameter 82) to the
switch S1 is operated
5
Send Basic Set (configured by parameter 82) to the
switch S2 is operated
Description
Disable
Enable
Description
Disable
Enable
30-09-2020 13:25
Pagina 8 van 16