Whirlpool 7MLSR6232 Manual de utilização e cuidados - Página 10

Procurar online ou descarregar pdf Manual de utilização e cuidados para Máquina de lavar roupa Whirlpool 7MLSR6232. Whirlpool 7MLSR6232 28 páginas. Whirlpool automatic washers use & care guide

Imprimir página

Washer basket is crooked

Was the washer basket pulled forward during loading?

The wash load should be balanced and not overloaded. Push

the basket to the center before starting washer.

Is the load balanced and the washer level?

The wash load should be balanced and not overloaded.

The washer must be level. The front feet should be properly

installed and the nuts tightened. Reset the rear leveling legs

(if needed). See the Installation Instructions.

The washer basket moves while washing.

This is normal.

Agitator operation

The top of the agitator is loose, or moves in only one

direction.

This is normal.

Dispensers clogged or bleach leaking

Did you follow the manufacturer's directions when adding

detergent and fabric softener to the dispensers?

Measure detergent and fabric softener. Carefully pour into the

dispensers. Wipe up all spills.

Dilute fabric softener in the fabric softener dispenser.

Did you put powdered or color-safe bleach in the liquid

chlorine bleach dispenser?

Add powdered or liquid color-safe bleach directly to the

basket. Do not use the chlorine bleach dispenser for color-

safe bleach.

Load too wet

Did you use the right cycle for the load being washed?

Select a cycle with a higher spin speed (if available).

Did you use a cold rinse?

Cold rinses leave loads wetter than do warm rinses. This is

normal.

Residue or lint on load

Did you sort properly?

Sort lint givers (towels, chenille) from lint takers (corduroy,

synthetics). Also sort by color.

Did you overload the washer?

The wash load must be balanced and not overloaded. Lint

can be trapped in the load if overloaded. Wash smaller loads.

Check the following:

Was paper or tissue left in the pockets?

Did you use enough detergent? Follow manufacturer's

directions. Use enough detergent to hold the lint in the water.

Is your water colder than 70°F (21°C)? Wash water colder

than 70°F (21°C) may not completely dissolve the detergent.

Stains on load

Did you follow the manufacturer's directions when adding

detergent and fabric softener?

Measure detergent and fabric softener. Use enough detergent

to remove soil and hold it in suspension.

Dilute fabric softener and add to the rinse portion of a cycle

only. Do not drip fabric softener on clothes.

Is there above average iron (rust) in water?

You may need to install an iron filter.

Did you properly sort the load?

Sort dark clothes from whites and lights.

Did you unload the washer promptly?

To avoid dye transfer, unload the washer as soon as it stops.

Load is wrinkled

Did you unload the washer promptly?

Unload the washer as soon as it stops.

Did you use the right cycle for the load being washed?

Use the Casual/Planchado Permanente (Casual/Permanent

Press) cycle or another cycle with low spin speeds (if

available) to reduce wrinkling.

Did you overload the washer?

The wash load must be balanced and not overloaded. Loads

should move freely during washing.

Was the wash water warm enough to relax wrinkles, or

are you using warm rinses?

If safe for the load, use warm or hot wash water. Use cold

rinse water.

Are the hot and cold water hoses reversed?

Check to be sure the hot and cold water hoses are connected

to the right faucets. See the Installation Instructions.

Load is tangled or twisted

Did you overload the washer?

The wash load must be balanced and not overloaded. Loads

should move freely during washing.

Did you wrap items around the agitator?

Drop items loosely into the washer. Do not wrap items around

the agitator.

Gray whites, dingy colors

Did you properly sort the load?

Dye transfer can occur when mixing whites and colors in a

load. Sort dark clothes from whites and lights.

Was the wash temperature too low?

Use hot or warm washes if safe for the load. Hot water should

be at least 111°F (44°C) to clean heavy soils.

Did you use enough detergent, or do you have hard

water?

Use more detergent for washing heavy soils in cold or hard

water.

Are the hot and cold water hoses reversed?

Check to be sure the hot and cold water hoses are connected

to the right faucets. See the Installation Instructions.