Whirlpool 7MWTW5010PW Manual do Proprietário - Página 8

Procurar online ou descarregar pdf Manual do Proprietário para Máquina de lavar roupa Whirlpool 7MWTW5010PW. Whirlpool 7MWTW5010PW 32 páginas.

Connect Drain Hose

5. Attach drain hose to drain port

If applicable, remove the red plastic plug from the black drain

port on the back of the washer.

If clamp is not already in place on elbow end of drain hose,

slide it over end as shown. Squeeze clamp with pliers and

slide black elbow end of drain hose onto black drain port and

secure with clamp.

For a laundry tub or standpipe drain, go to step 6.

For a floor drain, remove the pre-installed drain hose form as

shown in step 7. You may need additional parts with separate

directions. See the "Alternate Parts" section.

6. Place drain hose in standpipe

IMPORTANT: 4.5" (114 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay on

bottom of laundry tub. Drain hose form must be used.

Place hose into standpipe (shown in picture) or over side of

laundry tub.

7. Remove drain hose form (floor drain

installations only)

For floor drain installations, you will need to remove the drain

hose form from the end of the drain hose. You may need

additional parts with separate directions. See "Tools and

Parts."

It is the responsibility of the installer to install and secure the

drain hose into the provided plumbing/drain in a manner that

will avoid the drain hose coming out of and leaking from the

plumbing/drain.

Washer must be connected to water faucets with new inlet hoses

with flat washers (not provided). Do not use old hoses.

NOTE: Both hoses must be attached and have water flowing to

inlet valves. If you are only connecting to a cold water faucet, you

must use a Y-adapter (not provided).

8. Connect inlet hoses to water faucets

IMPORTANT: Do not overtighten hose or use tape or

sealants on valve. Damage to the valves can result.

Attach hose to hot water faucet. Screw on coupling by hand

until it is seated on washer. Use adjustable pliers to tighten

couplings an additional two-thirds turn. Repeat this step with

second hose for cold water faucet.