Whirlpool AWO/C 7420 S Manual - Página 10
Procurar online ou descarregar pdf Manual para Máquina de lavar roupa Whirlpool AWO/C 7420 S. Whirlpool AWO/C 7420 S 16 páginas.
Imprimir página
Problem
Detergent residues on
laundry after wash
Programme duration is
considerably longer or
shorter as indicated in the
"programme chart" or on
the display (if available)
Description of failure indicators
Failure
indicator blinks
"Water tap closed"
"Clean pump"
Whitish residues on dark fabrics are caused by insoluble compounds used in
phosphate-free powder detergents:
- avoid overdosing of detergent; use liquid detergent; select "Intensive
Rinse" option if possible; brush out the fabric
Normal function of the washing machine to adapt to factors that can have an
effect on the programme duration, like excessive foam formation, load
unbalance due to heavy laundry items, prolonged heating time resulting
from low inlet water temperature etc.. Moreover, the sensing system of the
washing machine adapts the programme duration to the size of the wash load.
Depending on these factors, the duration is recalculated during the
programme and updated if necessary; during such periods, an animation
appears on the display (if available). For small loads, the programme
time indicated in the "programme chart" may be reduced by up to 50%.
Appliance has no or insufficient water supply. The "Start(Pause)" light blinks.
Check whether:
• Water tap is fully open and water supply pressure is sufficient.
• Kinks are present in the water inlet hose.
• Mesh filter of water inlet hose is blocked (see "Care and Maintenance".
• The water hose is frozen up.
• The safety valve inspection window of your water inlet hose is red (provided your
appliance has a water supply hose as shown on picture "D" - see previous chap-
ter "Care And Maintenance"); replace the hose by a new one available through
our After-Sales Service or your specialist dealer.
After problem has been removed, restart programme by pressing "Start(Pause)".
If the fault occurs again, contact our After-Sales Service (see next chapter).
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
• Kinks are present in the drain hose, or the hose is blocked for another reason.
• Filter or pump is blocked (see chapter ("Draining Residual Water/Cleaning The
Filter"); make sure the water has cooled before draining the appliance).
• The drain hose is frozen up.
After problem has been removed, push the "Reset" button for at least 3 seconds;
afterwards restart the desired programme. If the fault occurs again, contact our
After-Sales-Service (see next chapter).
Causes - Solutions - Tips
Description - Causes - Solutions
GB 10