Whirlpool WASHER Manual de instruções de instalação - Página 4

Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar roupa Whirlpool WASHER. Whirlpool WASHER 8 páginas. Washing machine
Também para Whirlpool WASHER: Manual de instruções de instalação (16 páginas), Manual de instruções de instalação (27 páginas), Instruções para o utilizador (8 páginas), Instruções para o utilizador (20 páginas), Instruções para o utilizador (24 páginas), Instruções para o utilizador (8 páginas), Manual de instruções de instalação (20 páginas), Instruções para o utilizador (15 páginas), Manual de utilização e cuidados (40 páginas), Manual de instruções de instalação (16 páginas), Instruções para o utilizador (8 páginas), Gráfico do programa (2 páginas), Instruções de instalação (5 páginas)

Imprimir página
Whirlpool WASHER Manual de instruções de instalação
WARNING
Electrical Shock Hazard
Electrically earth this appliance.
Do not use an extension cord or an electrical portable
outlet device.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A 230 volt, 50 Hz., AC only, 10-amp, fused electrical supply is
required. A time-delay fuse or circuit breaker is recommended.
It is recommended that a separate circuit serving only this
appliance be provided.
This washer is equipped with a power supply cord having an
earthing plug.
To minimize possible shock hazard, the cord must be plugged
into a mating, earthing-type outlet, earthed in accordance with
local codes and ordinances. If a mating outlet is not available,
it is the personal responsibility and obligation of the customer
to have the properly earthed outlet installed by a qualified
electrician.
If codes permit and a separate earth wire is used, it is
recommended that a qualified electrician determine that the
earth path is adequate.
The installer is to confirm, through the local power supply
authority, if necessary, that the machine is connected to a
power supply with a maximum impedance of 0.068 + j0.043
ohms for phases (RA + jXA) and 0.0455 + j0.02844 ohms for
neutral (RN + jXN).

Before You Start

WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
NOTE: To prevent floor damage, set the washer onto cardboard
before moving across floor.
4

Electrical Requirements

INSTALLATION INSTRUCTIONS

Do not earth to a gas pipe.
Check with a qualified electrician if you are not sure the
washer is properly earthed.
Do not have a fuse in the neutral or earth circuit.
EARTHING INSTRUCTIONS
For an earthed, cord-connected washer:
This washer must be earthed. In the event of a malfunction
or breakdown, earthing will reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-earthing conductor and an earthing plug. The
plug must be plugged into an appropriate outlet that is
properly installed and earthed in accordance with all local
codes and ordinances.
WARNING:
Improper connection of the equipment-
earthing conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly earthed.
Do not modify the plug provided with the appliance – if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently connected washer:
This washer must be connected to an earthed metal,
permanent wiring system, or an equipment earthing
conductor must be run with the circuit conductors and
connected to the equipment-earthing terminal or lead on the
appliance.

Remove Shipping Strap

Removing the shipping strap is necessary for proper operation. If
the shipping strap is not removed, the washer will make excessive
noise.
1. Move the washer to within approximately 90 cm (3 ft) of the
final location.
2. The washer must be in the upright position and not tilted
before removing the shipping strap.