Ariston ASL70C Folheto de instruções - Página 4

Procurar online ou descarregar pdf Folheto de instruções para Secador Ariston ASL70C. Ariston ASL70C 12 páginas.

Imprimir página

1. Troubleshooting

19504265000 English.

Start and Programmes

Choosing a Programme

1. Plug the dryer into the electrical socket.

2. Sort your laundry according to fabric type (see

Laundry).

3. Open the door and make sure the filter is clean and

in place and the water container is empty and in place

(see Maintenance).

4. Load the machine and make sure that the items are

not in the way of the door seal. Close the door.

5. If the On/Off light is not lit; press the On/Off Button

6. Choose a programme by checking the Programmes

guide (see Programmes) as well as the indications for

each type of fabric (see Laundry).; - select a programme

by rotating the PROGRAMME knob.

7. Set a delay time and other options if necessary.

8. If you wish the buzzer to sound at the end of the

programme, press the ALARM Option button.

Easy Iron Programme

Easy Iron is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which fluffs the

fibres of clothing that has been left in the same position/location for an extended period of time. The cycle relaxes the fibres

and makes them easier to iron and fold.

! Easy Iron is not a drying programme and should not be used for wet articles of clothing.

For best results:

1. Do not load more than maximum capacity. These numbers refer to dry weight:

Fabric:

Max load:

Cotton and Cotton mix

2.5 kg

Synthetics

2 kg

Denim

2 kg

2. Unload the dryer immediately after the end of the drying cycle, hang, fold or iron the articles and put them away in the

closet. Should this not be possible, repeat the cycle.

The Easy Iron effect varies from one fabric to the next. It works very well on traditional fabrics like Cotton or Cotton mix,

and less well on acrylic fibres and on materials such as Tencel.®

{PDF Created 13/11/04 11:53}

9. Press the START button to begin. During the drying

programme, you can check on your laundry and take

out the items that are dry while the others continue

drying. When you close the door again, press START in

order to resume drying

10. During the last few minutes of Drying Programmes

before the programme is completed, the final COOL

TUMBLE phase is entered (fabrics are cooled), this

phase should always be allowed to complete.

11.When the programme is complete.

The buzzer will sound if the Alarm option was selected.

Open the door, take your laundry out, clean the filter

and replace it. Empty the water container

(see Maintenance).

If the Post Creasecare option has been selected and you

do not take the clothes out immediately the clothes will

tumble occasionally for 10 hours or until you open the

door.

12. Unplug the dryer.

TD4049 Issue 2

and replace