Firenzo CONTESSA Manual de instalação e operação - Página 7
Procurar online ou descarregar pdf Manual de instalação e operação para Fogão a lenha Firenzo CONTESSA. Firenzo CONTESSA 17 páginas. Freestanding clean air woodburner
Também para Firenzo CONTESSA: Manual (10 páginas), Instruções para o utilizador (9 páginas), Manual de instruções de instalação (8 páginas)
Imprimir página
6. FREESTANDING FLUE SYSTEM
INSTALLATION INSTRUCTIONS
1.
Position heater on floor protector ensuring all
heater clearances are correct as per clearances on
page 5.
2.
Once the location is confirmed, the appliance and
floor protector shall be fixed to the floor itself (refer to
page 6 & 7).
3.
Extend a plumb line from the centre of the fire flue
pipe spigot to the ceiling. Mark position on ceiling and
roof.
4.
Trim hole and nog as required ensuring that a
25mm safe clearance between combustible materials
and flue components is maintained. Fix with non-
combustible spacers and screws or clouts on all four
sides.
5.
Cut and frame (when required) an opening in the
roof, position the outer casing through the roof until it is
flush with the under side of the ceiling, making sure as
with the ceiling there is a 25mm safe clearance between
non-combustible materials and the flue components. Fix
as in step 4.
6.
Fix appropriate flashing around outer casing to the
roof to ensure a weatherproof seal.
7.
Assemble flue pipe sections ensuring all seams are
in line, the assembly is straight and crimped. Ends are
pointing downwards. Fix each joint with three stainless
rivets or self-tapping screws and seal.
8.
Place ceiling plate with folded edges upwards over
heater spigot.
9.
Position the flue pipe into the heater spigot. The
flue pipe can either lowered from the top as a single unit
or fed up from the room a length at a time, ensuring that
all joints are fixed properly.
10. Slide the inner casing into place, between the outer
casing and the flue pipe.
11. The flue pipe must extend 200mm above the outer
casing. Note: Extra lengths of flue pipe, inner and outer
casing may be required to achieve the minimum
clearance from the roof.
12. Slide top spreader over flue pipe down into outer
and inner casing and tighten.
13. Slide cowl over flue pipe until it rests on spreader.
Secure with rivets or self-tapping screws.
14. Fit rainhat. Do not fasten as it must be removable
for flue pipe cleaning.
15. Fix ceiling plate to ceiling maintaining an even gap
all around the flue pipe.
Note: Ensure ceiling plate is spaced off from the ceiling with ceramic spacers supplied.
CAUTION: Mixing of appliance or flue system components from different sources or modifying the dimensional
specifications of components may result in hazardous conditions. Where such action is considered the manufacturer
should be consulted in the first instance.
WARNING: The appliance and flue system shall be installed in accordance with AS/NZS 2918:2001 and the
appropriate requirements of the relevant building code or codes.
Contessa Guide 16/05/2013
7