Whirlpool AWZ 8000 PRO Manual de referência rápida - Página 5

Procurar online ou descarregar pdf Manual de referência rápida para Secador Whirlpool AWZ 8000 PRO. Whirlpool AWZ 8000 PRO 5 páginas.

In case of a malfunction of the appliance, a failure indication is shown or some LED lights

are blinking: (depending on the dryer model you have, the failure is displayed in letters or by

different layouts of blinking LED lights)

Message displayed

F02

F05

F06

F13

F14

F15

LED is not blinking

AFTER-SALES SERVICE

If the fault is still present once the above checks have been undertaken or should the fault occur for a second

time, switch the machine off. Please contact your After-Sales service representative (for more information, refer

to the warranty manual).

Please, have the following details ready when calling your after-sales service representative:

• The nature of the fault.

• The dryer type and model.

• The service code (the number after the word Service on the adhesive rating plate) on the right-hand side

when the door is open.

If the dryer appears damaged or defective, unplug the appliance and contact the machine owner for contacting

our After-Sales Service.

Failure codes

Check needed by customer before Service call

Turn OFF the dryer. Unplug the dryer for more than 3 seconds.

Plug the dryer and start a new cycle with humid laundry. If the

problem persists, please call Customer Service.

Turn OFF the dryer. Unplug the dryer for more than 3 seconds.

Clean the lint filter. Check if the ambient temperature is more than

5°C. Plug the dryer. Start a new cycle with humid laundry. If the

problem persists, please call Customer Service.

Turn OFF the dryer. Unplug the dryer. Empty the bottle. Clean the

fluff filter. Plug the dryer. Start a new cycle with humid laundry. If

the problem persists, please call Customer Service.

Turn OFF the dryer. Remove the load. Start the cycle again. If the

cycle starts, the dryer was overloaded. Stop the dryer and re-load

it again with half amount of laundry. If the failure indication occurs

again, please call Customer Service.

Turn OFF the dryer. Unplug the dryer. Call the Customer Service.

Turn OFF the dryer. Turn ON the dryer and restart the same

programme as before. If the same failure occurs again, turn OFF

the dryer. Unplug the dryer. Call the Customer Service.

LED is on or blinking