Whirlpool Cabrio WGD6600VW0 Manual de utilização e cuidados - Página 21
Procurar online ou descarregar pdf Manual de utilização e cuidados para Secador Whirlpool Cabrio WGD6600VW0. Whirlpool Cabrio WGD6600VW0 48 páginas. Steam fabric care system gas dryer
Também para Whirlpool Cabrio WGD6600VW0: Lista de peças (8 páginas)
Imprimir página
Reinstalling
the dryer
Follow the "installation instructions"
to locate, level and connect
the dryer.
The dryer light automatically turns on inside the dryer drum when
you open the door.
To change the drum light
1. Unplug dryer or disconnect power.
2. Open the dryer door. Locate the light bulb cover on the back
wall of the dryer. Remove the screw located in the lower right
corner of the
cover
Remove the cover.
3. Turn bulb counterclockwise.
Replace the bulb with a 10-watt
appliance
bulb only. Replace the cover and secure
with the
screw.
4. Plug in dryer or reconnect
power.
TROUBLESHOOTING
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly
avoid the cost of a service call._ln U.S.A. www, whirlpool.com/help - In Canada www,whirlpool.ca
Dryer will not run
•
Has a household fuse blown, or circuit breaker tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
•
Was a regular fuse used?
Use a time-delay fuse.
•
Is the dryer door firmly closed?
•
Was the Start button firmly pressed?
Large loads may require pressing and holding the Start
button for 2-5 seconds.
No heat
Has a household
fuse blown, or has a circuit breaker
tripped?
The drum may be turning, but you may not have heat.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
•
Is the valve open on the gas supply line?
Unusualsounds
•
Has the dryer had a period of non-use?
If the dryer hasn't been used for a while, there may be a
thumping sound during the first few minutes of operation.
Is a coin, button or paper clip caught between the drum
and front or rear of the dryer?
Check the front and rear edges of the drum for small objects.
Clean out pockets before laundering.
Is it a gas dryer?
The gas valve clicking is a normal operating sound.
•
Are the four legs installed,
and is the dryer level front to
back and side to side?
The dryer may vibrate if not properly installed. See the
Installation Instructions.
•
Is the clothing knotted
or balled up?
When balled up, the load will bounce, causing the dryer to
vibrate. Separate the load items and restart the dryer.
Dryer displaying
code message
•
"PF" (power failure), check the following:
Was the drying cycle interrupted by a power failure?
Press and hold START to restart the dryer.
•
"F" Variable (F1, F2, F2O, etc.) service
codes:
Call for service.
Clothes
are not drying satisfactorily,
drying times are too
long, or load is too hot
•
Is the lint screen clogged with lint?
Lint screen should be cleaned before each load.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow
these instructions can result in death
or fire.
•
Is the exhaust vent or outside exhaust
hood clogged
with
lint, restricting
air movement?
Run the dryer for 5-10 minutes. Hold your hand under the
outside exhaust hood to check air movement. If you do not
21