Whirlpool duet GEW9200LQ0 Manual de utilização e cuidados - Página 15

Procurar online ou descarregar pdf Manual de utilização e cuidados para Secador Whirlpool duet GEW9200LQ0. Whirlpool duet GEW9200LQ0 28 páginas. Duet electronic electric dryer

Imprimir página

Connect Vent

1. Using a 4 in. (10.2 cm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure the vent is

clean. The dryer vent must fit over the dryer exhaust outlet

and inside the exhaust hood. Make sure the vent is secured

to exhaust hood with a 4 in. (10.2 cm) clamp.

2. Move dryer into final position. Do not crush or kink vent.

Make sure dryer is level.

3. (On gas models) Check to be sure there are no kinks in the

flexible gas line.

Reverse Door Swing

You can change your door swing from a right-side opening to a

left-side opening, if desired.

Locate the door reversing kit that was shipped in the drum of

your dryer. You will need these parts to complete the door

reversal.

Loosen door trim

1. Place a towel or soft cloth on top of the dryer or work space

to protect the surface.

2. Loosen the plastic trim above and below the handle filler.

Carefully pull out on the trim until it unsnaps. Remove the

handle filler and set aside.

1. Plastic trim

2. Handle filler

3. Loosen the plastic trim above and below the hinge cover.

Carefully pull out on the trim until it unsnaps. Remove the

hinge cover and set aside.

1. Plastic trim

2. Hinge cover

Keep the original handle filler and hinge cover in case you

decide to return the door to its original position.

A new handle filler and hinge cover are provided in the door

reversing kit that will be installed in a later step.

Remove the door

1. Open the dryer door. Remove the 5 screws that hold the door

2. Lift and pull forward on the door so that the screwhead clears

3. Lay the dryer door on a flat, protected surface with the inside

4. Remove the 6 screws to release the outer door assembly

5. Lift the inner door assembly off of the outer door assembly.

hinge on the front panel of the dryer. Loosen, but do not

remove, the screw with the top keyhole opening LAST

(second from the top).

the keyhole. Remove the door.

door assembly facing up. Remove the 2 screws holding the

handle to the door. Pull handle straight out and set aside. A

new handle is provided.

NOTE: Keep this handle in case you decide to return the door

to its original position.

from the inner door assembly (see illustration). It is important

that you remove ONLY the 6 indicated screws.

Set the outer door assembly aside.