Whirlpool WGD7990XG0 Manual de instruções de instalação - Página 6
Procurar online ou descarregar pdf Manual de instruções de instalação para Secador Whirlpool WGD7990XG0. Whirlpool WGD7990XG0 32 páginas. Gas dryer
Também para Whirlpool WGD7990XG0: Manual de instruções de instalação (32 páginas)
Imprimir página
Back view:
41/4"
(108 ram)
T
301/2''
(775 ram}
NOTE:
Most installations require a minimum 5" (102 mm)
clearance behind the dryer for the exhaust vent with elbow.
See "Venting Requirements".
Installation
spacing
for recessed
area or closet
installation
The dimensions shown below are for the recommended spacing
for this dryer.
[] Additional spacing should be considered for ease
of installation and servicing.
[] Additional clearances might be required for wall, door,
and floor moldings.
[] Additional spacing of 1" (25 mm) on all sides of the dryer
is recommended
to reduce noise transfer.
[]
For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.Companion
appliance spacing should also be
considered.
Recommended
installation spacing:
34" recommended
(864 ram)
l
18" rain.
_457 =
1 ii
(25 ram)
48 in?
(310 cm2)
_0
24 in?
(155 cm-3
Mobile
home
= Additional
installation
requirements:
This dryer is suitable for mobile home installations.
The installation must conform to the Manufactured
Home Construction
and Safety Standard, Title 24 CFR,
Part 3280 (formerly the Federal Standard for Mobile home
construction
and Safety, Title 24, HUD Part 280) or Standard
CAN/CSA-Z240
MH.
Mobile
home
installations
require:
All dryers:
[]
Metal exhaust system hardware, available for purchase
from your dealer. For further information, see "Assistance
or
Service" section in your "Use and Care Guide".
[]
For
[]
Special provisions must be made in mobile homes to
introduce outside air into dryer. Openings (such as a nearby
window) should be at least twice as large as dryer exhaust
opening.
gas dryers mobile home installations:
Mobile Home Installation Hold-down
Kit Part Number
346764 is available to order. For further information, see
"Assistance
or Service" section in your "Use and Care
Guide".
INSTALL
LE¥ LING
LEGS
Excessive Weight Hazard
Use two or more people to move and install dryer.
Failure to do so can result in back or other injury.
. Prepare
dryer for leveling
legs
To avoid damaging floor, use a large flat piece of cardboard
from dryer carton; place under entire back edge of dryer.
Firmly grasp dryer body (not console panel) and gently lay
dryer down on cardboard.
6