Whirlpool WGD9151YW Manual de instalação - Página 14

Procurar online ou descarregar pdf Manual de instalação para Secador Whirlpool WGD9151YW. Whirlpool WGD9151YW 36 páginas. Installation guide
Também para Whirlpool WGD9151YW: Manual do utilizador (32 páginas), Manual de instruções (8 páginas), Manual de utilização e cuidados (40 páginas)

CONNECT INLET HOSE

(Steam models only)

For non-steam models, proceed to "Connect Vent".

The dryer must be connected to the cold water faucet using the

new inlet hoses. Do not use old hoses.

NOTE: Replace inlet hoses after 5 years of use to reduce the risk

of hose failure. Record hose installation or replacement dates on

the hoses for future reference.

Periodically inspect and replace hoses if bulges, kinks, cuts,

wear, or leaks are found.

Turn cold water off, remove hose,

and replace rubber washer

Turn cold water faucet off and remove washer inlet hose.

Check and see if rubber washer is in the "Y" connector.

Remove old rubber washer from inlet hose and replace with

new rubber washer provided.

Attach short hose and

"Y" connector

If space permits, attach the female end of the "Y" connector

to the cold water faucet. See figure A.

If "Y" connector cannot be attached directly to the cold water

faucet, the short hose must be used. See figure B. Attach

short hose to cold water faucet. Screw on coupling by hand

until it is seated on faucet. Then attach "Y" connector to male

end of the short hose. Screw on coupling by hand until it is

seated on connector.

Tighten couplings

Using pliers, tighten the couplings with additional

two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling

can result.

Attach long hose to "Y"

connector and tighten couplings

One end of the long hose has a

wire mesh strainer inside the coupling. Attach this end to the

"Y" connector. Attach washer cold inlet hose to other side of

"Y" connector. Screw on coupling by hand until it is seated

on connector. Using pliers, tighten the couplings an additional

two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.