Whirlpool WGD94HEAW Manual de instruções de instalação - Página 21
Procurar online ou descarregar pdf Manual de instruções de instalação para Secador Whirlpool WGD94HEAW. Whirlpool WGD94HEAW 44 páginas. 7.4 cu. ft. duet steam gas dryer with advanced moisture sensing
Também para Whirlpool WGD94HEAW: Manual de instruções (8 páginas), Manual de utilização e cuidados (40 páginas)
Imprimir página
2.
Move the door strike
Using a TORX
T25 screwdriver, remove the 2 screws
®
securing the door strike to the door frame of the dryer.
Remove the 4 screws above and below the door strike and
set aside for later use. Rotate the strike 180° and attach to
the opposite side of dryer door frame, as shown.
3.
Remove inner door from
outer door
Release tab
Position the door with the inside of the door facing up. Using
a Phillips screwdriver, remove the 13 screws securing the
inner door to the outer door. Lift off the inner door and set
aside.
NOTE: There is a small release tab on each side of the door.
If the inner and outer door do not separate easily, slide a
credit card, putty knife, or similar flat object between the inner
and outer doors at the locations shown to release the tab.
4.
Latch
Using a TORX T25 screwdriver, remove the 3 TORX screws
securing the latch plate and the 5 screws holding the hinge
assembly in place.
5.
Latch
Release tab
Using a TORX T25 screwdriver, reinstall the latch plate and
hinge assembly on the opposite sides from which they were
removed.
Remove hinge and latch
from inner door
Reinstall hinge and latch on
opposite sides
Hinge
Latch
21