Whirlpool WGD97HEXW0 Manual de instruções de instalação - Página 10
Procurar online ou descarregar pdf Manual de instruções de instalação para Secador Whirlpool WGD97HEXW0. Whirlpool WGD97HEXW0 38 páginas. Gas dryer
Também para Whirlpool WGD97HEXW0: Manual de utilização e cuidados (36 páginas)
Imprimir página
Venting
Requirements
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can result in death
or fire.
WARNING:
To reduce the risk of fire, this dryer MUST BE
EXHAUSTED OUTDOORS.
iMPORTANT:
Observe all governing codes and ordinances.
Dryer exhaust must not be connected
into any gas vent,
chimney, wall, ceiling, attic, crawlspace,
or a concealed space
of a building. Only rigid or flexible metal vent shall be used for
exhausting.
(
0'
(102 ram)
4" (102 ram) heavy metal exhaust vent
[] Only a 4" (102 mm) heavy metal exhaust vent and clamps
may be used.
[] Do not use plastic or metal foil vent.
Rigid
metal
vent:
[] Recommended
for best drying performance
and to avoid
crushing and kinking.
Flexible
metal
vent:
(Acceptable only if accessible to clean)
[] Must be fully extended and supported
in final dryer location.
[] Remove excess to avoid sagging and kinking that may result
in reduced airflow and poor performance.
[] Do not install in enclosed walls, ceilings, or floors.
[] The total length should not exceed 73/4ft. (2.4 m).
NOTE:
If using an existing vent system, clean lint from entire
length of the system and make sure exhaust hood is not plugged
with lint. Replace plastic or metal foil vents with rigid metal or
flexible metal vents. Review Vent system chart and if necessary,
modify existing vent system to achieve best drying performance.
Exhaust
hoods:
[] An exhaust hood should cap the vent to keep rodents and
insects from entering the home.
[] Must be at least 12" (305 mm) from ground or any object
that may obstruct exhaust (such as flowers, rocks, bushes,
or snow).
[] Do not use an exhaust hood with a magnetic latch.
Recommended
Styles:
Louvered Hood
Acceptable
Style:
Angled Hood
Elbows:
Box Hood
[] 45 ° elbows provide better airflow than 90 ° elbows.
Be
Clamps:
[] Use clamps to seal all joints.
[] Exhaust vent must not be connected or secured with screws
or other fastening devices that extend into interior of duct
and catch lint. Do not use duct ta }e.
,cz
improper venting can cause moisture
and lint to collect
indoors, which may result in:
[] Moisture damage to woodwork,
furniture, paint, wallpaper,
carpets, etc.
[] Housecleaning
problems and health problems.
10