Whirlpool XCEM2765FQ0 Manual de instruções de instalação - Página 19
Procurar online ou descarregar pdf Manual de instruções de instalação para Secador Whirlpool XCEM2765FQ0. Whirlpool XCEM2765FQ0 23 páginas. Commercial gas or electric dryer
Imprimir página
1. Check the electrical requirements. Be sure that you have
the correct electrical supply and the recommended earthing
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
WARNING
Electric Shock Hazard
This dryer must be earthed.
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electric shock.
5. Plug into a grounded outlet, or connect power.
COMPLETE INSTALLATION
6. Check dryer operation (some accumulated time may be
on the timer due to factory testing). Close dryer door. Insert
coins in slide and press slide in slowly. (Operating time will
accumulate per number of coins and type of timing cam
used.) Push START button. Using a full heat cycle (not the
air cycle), let the dryer run for at least five minutes. Dryer will
stop when time is used up.
NOTE: Dryer door must be closed for dryer to operate.
When door is open, dryer stops, but timer continues to run.
To restart dryer, close door and push START button.
7. Gas models only: Open the dryer door. Check that the
inside of the dryer is warm. If the burner does not ignite and
you can feel no heat inside the dryer, shut off dryer for five
minutes. Check that all supply valve controls are in "ON"
position and that the electrical cord is plugged in. Repeat
five-minute test.
8. If drying time is too long, make sure that the lint screen is
clean and that there are no obstructions to airflow in the
dryer vent system.
9. Restart the dryer and allow it to complete a full heat cycle
(not air cycle) to make sure it is working properly.
19