Whirlpool YWED9600TU1 Manual de utilização e cuidados - Página 11
Procurar online ou descarregar pdf Manual de utilização e cuidados para Secador Whirlpool YWED9600TU1. Whirlpool YWED9600TU1 48 páginas. Electronic electric dryer
Imprimir página
8. Using pliers, tighten the couplings with an additional two-
thirds turn.
A. Inlet to cold water
NOTE: Do not overtighten.
Damage to the coupling can
result.
9. Attach angled end of long hose to fill valve at bottom of dryer
back panel. Screw on coupling by hand until it is seated on fill
valve connector.
10. Using pliers, tighten the coupling with an additional two-
thirds turn.
NOTE: Do not overtighten.
Damage to the coupling can
result.
11. Check that the water faucets are on.
12. Check for leaks around "Y" connector, faucet and hoses.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Be sure the water faucets are on.
5. Check for leaks around "Y" connector, faucet and hoses.
6. Check the dryer's final location. Be sure the vent is not
crushed or kinked.
7. Check that the dryer is level. See "Level Dryer."
8. Plug into a grounded 4 prong outlet. Turn on power.
9. Remove the blue protective film on the console and any tape
remaining on the dryer.
10. Read "Dryer Use."
1f. Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
12. If you live in a hard water area, use of a water softener is
recommended
to control the buildup of scale through the
water system in the dryer. Over time, the buildup of lime scale
may clog different parts of the water system, which will
reduce product performance.
Excessive scale buildup may
lead to the need for certain part replacement or repair.
13. Select a Timed Dry heated cycle, and start the dryer. Do not
select the Air Only Temperature setting.
If the dryer will not start, check the following:
•
Controls are set in a running or "On" position.
•
Start button has been pushed firmly.
•
Dryer is plugged into an outlet and/or electrical supply
is connected.
•
Household fuse is intact and tight, or circuit breaker has
not tripped.
•
Dryer door is closed.
This dryer automatically
runs an installation diagnostic routine at
the start of its first cycle.
If you receive an L2 code, there may be a problem with your
home power supply keeping the dryer's heater from turning
on. See "Troubleshooting."
If you receive an AF code, your dryer vent may be crushed or
blocked. See "Troubleshooting."
NOTE: You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.
Check the levelness of the dryer. Check levelness first side to
side, then front to back.
If the dryer is not level, prop up the dryer using a wood block.
Use a wrench to adjust the legs up or down and check again for
levelness.
11