Whirlpool 30 " Eye-Level Gas Range Instruções de instalação e manual de utilização e cuidados - Página 13

Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação Whirlpool 30 " Eye-Level Gas Range. Whirlpool 30 " Eye-Level Gas Range 32 páginas. Freestanding gas range with self-cleaning oven
Também para Whirlpool 30 " Eye-Level Gas Range: Manual de instruções de instalação (11 páginas), Instruções de instalação e manual de utilização e cuidados (28 páginas), Manual de instruções de instalação (11 páginas), Instruções de instalação (5 páginas), Manual de instruções de instalação (28 páginas), Manual de instruções de instalação (48 páginas), Manual de instruções de instalação (32 páginas), Manual de instruções de instalação (12 páginas), Instruções de instalação (5 páginas), Manual de instruções de instalação (7 páginas), Manual de instalação (7 páginas), Manual de instruções de instalação (7 páginas), Instruções de instalação (5 páginas), Manual de instruções de instalação (7 páginas), Manual de instruções de instalação (10 páginas)

Whirlpool 30
Non-Vented (recirculating) Installation Filters
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit Number
W10272068.
To replace charcoal filter:
1. Cover the grille that covers the blower motor with the
charcoal filter so that the slots on the filter correspond to the
pins on the sides of the motor grille.
A
B
A. Charcoal filter
B. Pins
C. Blower motor
2. Turn the charcoal filter clockwise to lock it.
3. Repeat steps 1-2 on the other filter.
C
Replacing a Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new bulb, do not
touch bulb with bare fingers. Replace bulb, using tissue or
wearing cotton gloves to handle bulb.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120-volt, 50-watt
maximum halogen bulb with a GU10 base. Turn it clockwise
to lock it into place.
4. Repeat steps 2-3 for the other bulb if needed.
5. Reconnect power.
13