Whirlpool 30 " Eye-Level Gas Range Manual de instruções de instalação - Página 17

Imprimir página

3. Remove plastic cover from gas pressure regulator cap.

4. Turn gas pressure regulator cap counterclockwise with a ⁵⁄₈"

(1.6 cm) combination wrench to remove.

NOTE: Do not remove the spring beneath the cap.

A. Plastic cover

B. Gas pressure regulator cap with solid end facing out

C. Gas pressure regulator cap with hollow end facing out

D. Washer

E. Gas pressure regulator cap

5. Turn over the gas pressure regulator cap and reinstall on

regulator so that the hollow end faces out and the marking

LP" is facing the direction shown in the above drawing.



6. Replace plastic cover over gas pressure regulator cap.

To Convert Surface Burners (Natural Gas to LP Gas)

1. Remove burner cap.

2. Remove the burner base.

A. Igniter electrode

B. Burner cap

C. Gas tube opening

D. Burner base

Side view before

Side view after

3. Apply masking tape to the end of a 7 mm (⁹⁄₃₂") nut driver to

help hold the gas orifice spud in the nut driver while changing

it. Press nut driver down onto the gas orifice spud and

remove by turning it counterclockwise and lifting out. Set gas

orifice spud aside.

A. Igniter electrode

B. Orifice spud

C. Orifice spud holder

D. Screws

4. Remove the orifice spuds shipped in the literature package in

the oven. Gas orifice spuds are stamped with a number,

marked with 1 color dot, and have a groove in the hex area.

Replace the Natural gas orifice spud with the correct LP gas

orifice spud.

A. LP groove

Refer to the following chart for correct LP gas orifice spud

placement.

LP Gas Orifice Spud Chart for Surface Burners

Burner Rating

Color

14,000 BTU

Silver

8,000 BTU

Red/Orange

5,000 BTU

Red/Blue

1,200 BTU

Black/Orange

NOTE: Refer to the Model Number and Serial Number Plate

located on the oven frame behind the top right side of the oven

door for proper sizing of spuds for each burner location.

5. Place Natural gas orifice spuds in the orifice spud bag.

IMPORTANT: Keep the Natural gas orifice spuds in case of

reinstallation with Natural gas.

6. Replace the burner base.

7. Replace burner cap.

8. Repeat steps 1-7 for the remaining burners.

Size (mm)

Number

1.05

L105

0.85

L85

0.65

L65

0.32

L32