Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD Instruções de instalação e manual de utilização e cuidados - Página 8

Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD. Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD 28 páginas. 30" (76.2 cm) wall-mount canopy range hood

Imprimir página

Install Range Hood

1. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

2. Remove the grease filter. See "Range Hood Care" section.

3. Level the range hood and tighten upper mounting screws.

4. Install (2) 5 x 45 mm lower mounting screws and tighten.

Use the optional wall anchors if needed.

Connect Vent System

1. Install transition on top of hood (if removed for shipping)

with (2) 3.5 x 9.5 mm sheet metal screws.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over transition piece.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

For non-vented (recirculating) installations only:

1. Assemble the air deflector with the duct cover bracket with

2. Measure from the bottom of the air deflector to the bottom

3. Cut the duct to the measured size "X."

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

7. Reassemble the air deflector to the duct cover bracket with

8. Seal connections with vent clamps.

2 assembly screws provided with the Recirculation Kit.

A. Vent cover bracket

B. 2.9 x 6.5 mm screws

C. Deflector

of the hood outlet.

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

D. Vent duct

E. Exhaust outlet

outlet from the hood.

2 assembly screws.