Whirlpool RCH3660 Manual de instruções de instalação
Procurar online ou descarregar pdf Manual de instruções de instalação para Campânula de ventilação Whirlpool RCH3660. Whirlpool RCH3660 6 páginas. Vented kitchen shelf hood for 120 v. operation
Imprimir página
VENTED
KITCHEN
SHELF HOOD
FOR 120 V. OPERATION
IMPORTANT
FOR VENTLESS
INSTALLATION,
DIS-
REGARD
THIS INSTRUCTION
SHEET.
USE VENTLESS
KIT
INSTRUCTION
SHEET FOR MODEL RCH3660.
KITCHEN
RANGE HOOD
I
MODEL
RH3330XL-1
READ AND SAVE THESE INSTRUCTIONS
Before
you
begin,
read
the
following
instructions
completely
and carefully.
It followed,
they will simplify
the installation
job.
'PJJORTANT:
OBSERVE ALL GOVERNING
CODES
AND ORDINANCES
SAVE THESE INSTRUCTIONS
FOR THE LOCAL
ELECTRICAL
INSPECTOR'S
USE
FOR USE WITH WHIRLPOOL
"J" AND "L"
LINE MICROWAVE
OVENS
BEFORE YOU USE YOUR SHELF HOOD:
Be sure your shelf hood is installed
on an appropriate
wall
strong enough
to support
this appliance.
NOTE: The shelf hood is designed
to support
a microwave
oven with a net weight
of up to 75 pounds,
plus approved
accessories,
cookbooks,
utensils,
and food.
The area used for the installation
must be suitable
for the
size, function,
and protection
(from elements)
of the shelf
hood.
WARNING:
THE
WEIGHT
OF THE
MICROWAVE
MAY
EXCEED
YOUR
LIFTING
ABILITY.
WE RECOMMEND
ASSISTANCE.
FOR USE OVER WHIRLPOOL
CONVENTIONAL
GAS AND ELECTRIC
RANGE COOKTOPS
CAUTION:
When mounting
the shelf hood to a wall, you
must locate 2 studs in the wall. Do not attempt to install the
hood if the 2 wall studs are not found.
Be careful when drilling holes into awall. Electrical
wires and
water pipes may be concealed
behind the wall covering.
-
TOOLS AND MATERIALS
REQUIRED
l
Drill, electric
or
ratchet
drive, with
3/8", 3/16" and l/8"
wood bit (for
drilling
starter
holes)
and l-1/4"
wood
bit
(to drill an access
hole in the cabinet
or kitchen
wall for
the electric
power
line.)
l
One
common
and one
phillips
head
screwdriver
(to
secure
hood mounting
screws
to the cabinet
and hood
sheet
metal
parts).
l
Pliers
(for opening
knockouts).
l
Pencil,
ruler
and level for marking
cabinet
locations.
l
Saber saw or keyhoie saw for cutting the wall or cabinet
openings.
l
Caulking,
metal snips, duct tape, ducts (with elbow and
transition,
if necessary)
and wall cap or roof cap, as
required.
-512/&j
3/ 79
Page 1