Whirlpool UXT2030AD Instruções de instalação e manual de utilização e cuidados - Página 9
Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação Whirlpool UXT2030AD. Whirlpool UXT2030AD 32 páginas. 30" (76.2 cm) range hood
Também para Whirlpool UXT2030AD: Instruções de instalação e manual de utilização e cuidados (28 páginas), Instruções de instalação e manual de utilização e cuidados (28 páginas)
Imprimir página
8. Prepare Range Hood Vents
and Mounting Tabs
B
A
Install Strain Relief
■
Install a UL listed/CSA approved 1/2" (13 mm) strain
relief (A).
Mounting Tabs
■
Start a #8-18 x 5/8" (4.2 x 16 mm) truss-head screw into
the mounting tab (D) on each side of the range hood
as shown in the inset. Insert the screws approximately
2 turns into the mounting tab holes.
7" (17.8 cm) Round Vent Installations
■
Remove both top knockouts (B and C).
9. Attach Vent Damper or Transition
7" (17.8 cm) Round Vent Mounting Plate
B
Using (2) short Phillips head screws, install the 7" (17.8 cm)
■
round vent mounting plate over the vent knockouts
removed in Step 8. Position the wide flange (C) to the front.
NOTE: An optional 7" (17.8 cm) round damper (A),
Part Number W10355451 is available as an accessory.
For information on ordering, see the "Assistance
or Service" section.
If installing the optional round damper, position
■
it over the round vent mounting plate.
D
x2
C
A
C
10. Mount Range Hood
Lift the range hood into place, positioning the rear slots
■
over the mounting brackets.
Using a Phillips screwdriver, push on the screws that
■
are started into the top mounting tabs and bend the
tabs against the cabinet side walls. Attach the screws
to the cabinet side walls.
IMPORTANT: Do not overtighten the screws.
For direct wire installations, run the home power supply
■
cable according to the National Electric Code or CSA
standards and local codes and ordinances. There must
be enough wiring from the fused disconnect (or circuit
breaker) box to make the connection in the range hood
electrical terminal box.
Tighten the strain relief screws.
■
NOTE: Do not reconnect power until the installation
is complete.
OPTIONAL: If you prefer, bend the rear tabs against
the rear of the range hood and attach to the wall using
#8-18 x 5/8" (4.2 x 16 mm) truss-head screws.
11. Connect Vent System
Connect the ventwork to the range hood.
■
Seal joints with vent clamps or duct tape to make
■
secure and airtight.
Check that the backdraft dampers work properly.
■
9