AER Lily one Manual de instalação - Página 5
Procurar online ou descarregar pdf Manual de instalação para Acessórios para instrumentos musicais AER Lily one. AER Lily one 12 páginas. Twin source rechargeable pick up system for acoustic instruments
Também para AER Lily one: Início rápido (3 páginas)
Imprimir página3. Woodwork
•
Drill or ream a 12 mm hole to fit the end-
pin pre-amp. Make sure that it is centred
properly and in a 90° angle to the end
block.
•
Then, drill a 2.5 mm hole through the
saddle slot and the top of the guitar at the
edge of the slot. It is immaterial which side
is drilled, bass or treble side.
Avoid hitting the braces!
•
For installing the piezo pickup there
should be no routing required if the slot
has a regular length and depth!
The width and depth should be sufficient.
•
Take the piezo pickup and lead the mini-
jack through the hole in your instrument.
The piezo will fit most saddle slots easily.
The 6 piezoelectric crystals sit underneath
the strings, they don't have to be centred.
You can use the cable as a spring to keep
the pickup in place. Make sure the saddle
slides easily into the slot, however it
should not tilt. [Paragraph ist doppelt]
•
Fixate the saddle with masking tape to
protect the piezo pickup during installati-
on, and use a strip of masking tape to stick
the piezo pickup cable inside the guitar to
a near top brace, as strain relief.
•
The saddle will sit higher now that the
piezo is installed. For proper playing
action, remove some material from the
saddle. Use double side tape to fixate
sanding paper to a completely flat surface
and sand off enough material from the
bottom of the saddle to match your play-
ing requirement. Always check that the
bottom of the saddle stays flat.