Calea Ambix Activ Manual de referência rápida - Página 2

Procurar online ou descarregar pdf Manual de referência rápida para Equipamento médico Calea Ambix Activ. Calea Ambix Activ 2 páginas. Ambulatory pump & accessories
Também para Calea Ambix Activ: Manual do utilizador (16 páginas)

Imprimir página
Priming, Inserting & Removing
the Ambix activ giving set
PRIMING THE SET MANUALLY:
You will need to prime your Ambix activ giving set slowly.
Close the Ambix activ clamp.
Spike your bag with the Ambix activ giving set and hang up.
Hold the line taught.
2
Create an 'S' shape with the line.
3
Open the Ambix activ clamp to start priming the line. The blue cap on the end
will prevent any leakages.
4
Close the Ambix activ clamp when the line is fully primed. Remove blue cap
prior to connection.
1
2
3
INSERTING THE GIVING SET.
Open the door with the lever.
Match up the green mark on the Ambix activ giving set to green mark on the Ambix
activ pump. Make sure the foot of the clamp is facing outwards.
Position the top of the blue section on the Ambix activ giving set into the blue section on
the Ambix activ pump.
Close the pump door.
REMOVING THE GIVING SET.
Press STOP/ESC.
Press ON/OFF for 3 seconds or more.
Open the pump door.
Remove the giving set
Dispose of the set, following the guidelines in the main guide.
How to use your Ambix activ pump
Switch the pump on.
Press MODE and choose from Volume/Time, Continuous,
Intermittent, or Ramp modes (see manual) as discussed by your clinical team.
Start the infusion.
(To retrieve the last infusion volume, press the information button)
1
Keypad lock
4
Switch pump on
Hold to reset for
new information
Alarm silence
Pump priming
Mode:
Volume/Time
Continuous
Intermittent
Ramp
Reset to factory
settings
Set flow rate
Set time threshold
Set target volume
Stop the pump or
silence the alarm
Start the pump
Ambix Activ Ambulatory Pump and Accessories -
Quick Reference Guide
How to clean your Ambix activ pump
Before cleaning your pump, make sure your pump is disconnected from you and the
power mains.
It is very important that you clean your pump
When contamination occurs.
At least once a week.
Once cleaned leave the pump to dry for approximately 5 minutes before using.
Pump and Holder
Clean using:-
Lint-free, damp cloth or lint-free cloth soaked in disinfectant.
Contact pins with cotton wool soaked in disinfectant.
Freephone 24 hour Advice Line
0800 121 8300