3Com AirProtect Enterprise Engine 6100 Manual de configuração rápida - Página 9
Procurar online ou descarregar pdf Manual de configuração rápida para Hardware de rede 3Com AirProtect Enterprise Engine 6100. 3Com AirProtect Enterprise Engine 6100 12 páginas. Secure converged networks enterprise edition
Também para 3Com AirProtect Enterprise Engine 6100: Manual do produto (15 páginas), Manual de configuração rápida (14 páginas)
Imprimir página
Step 9: Power up and Connect Sensors to the Network
Power and Connect the Sensor to the Network
A.
Ensure that the 3Com AirProtect Enterprise Server is already running on your network.
Note: Make sure that a DNS entry 'wifi‐security‐server' is set up on all DNS Servers. This entry should point to the IP address of the
Server. Otherwise, configure the Sensor manually. Please refer to the 3Com AirProtect Enterprise Installation Guide for details.
B.
Use network interface cables to connect Sensors to all the network segments (subnets) that need to be protected.
Make sure that the network segment is DHCP enabled. Otherwise, configure the IP address of the Sensor manually.
Note: Log in to the Server using SSH. Run the command 'get sensor list' to check if all the Sensors added have been detected by the Server.
If all the Sensors are connected, go to the next step. If some Sensors are not connected, then you may need to configure the Sensors
manually.
3Com® AirProtect Enterprise Engine 6100 Quick Setup Guide
7