Alcom Premium ADT1308 Manual de instruções - Página 14

Procurar online ou descarregar pdf Manual de instruções para Telefone Alcom Premium ADT1308. Alcom Premium ADT1308 18 páginas. Telephone

Imprimir página
registered handset will displays HS2 or HS3 on the LCD according to the registration sequence.
3.
Press
key on base unit to locate the handsets.
OPERATION
Speakerphone operation & volume control
Press
key once to obtain a dial tone, dial your number, when you hear the other party start your
conversation. You can also answer an incoming call by pressing the
During the speakerphone operation, the user can adjust the speaker volume level by pressing the ▲ or ▼
key .Total 6 levels for selection.
key to use earpiece, you can press the ▲ or ▼ key to adjust the earpiece volume, total 5
If you press
levels for selection.
Mute the MIC
During a call, press MUTE key once to mute the MIC and MUTE will show on LCD. Press MUTE key again to
get back to the call and the MUTE will disappear.
Caller ID – type I & II
TYPE I
After you have applied the caller ID service, you can see the caller party phone number during an incoming
ring.
TYPE II
During the conversation, the phone number of the incoming call of the second caller can be seen in the unit.
Note: Above caller ID services must be subscribed /supported by your telephone service provider.
Flash function
When a number is dialled and the line is busy, press R/CLR key and then press RD/P key to dial it out again or
enter a new number.
When on an external call, press R/CLR to access call waiting (2
Press the key again to toggle between your two callers.
Note: Above call waiting services must be subscribed /supported by your telephone service provider.
Pause
Press RD/P key will insert a time delay of 3.6 seconds in a dialing sequence.
Pre-dialing
The unit has pre-dialing function, you may enter and edit the number before dialing out.
The following procedure describes how to use this function:
In idle mode, enter the number you want to dial. For wrong entries you can press R/CLR key to correct the
1.
number.
2.
Press
or
Redial function
key once, the unit will dial out the number show on the LCD.
key once.
nd
Call) when you hear the signal.
14