AlcoMate CA 2000 Manual
Procurar online ou descarregar pdf Manual para Equipamento de teste AlcoMate CA 2000. AlcoMate CA 2000 2 páginas. Digital alcohol detector
Imprimir páginaJUL 2 3 2004
AlcoMate Model CA 2000
The CA2000 is intended to measure alcohol in human breath. Readings obtained by this device are used in the diagnosis of
alcohol intoxication. The accuracy of this device has been established at a Blood Alcohol Concentration of 0.008 and 0.032.
Accuracy at a Blood Alcohol Concentration greater than 0.032 has not been evaluated.
Part names
Breath out
-
do ncg cov-,
wAh hand
during sampling
__Acohol level
Breath pip
g~Display
window
Warning lamp
,..
Ready
lamp
Power switch
DC adaptor socket
Battery low lamp
Preparation
I.
Install the 9 Volt Battery, supplied.
PUSH ,
"
2. The tester comes with one plastic mouthpiece already over the breath pipe. You may wish to replace the mouthpiece for
use by another person for sanitary reasons. To change mouthpieces, align the slot in the mouthpiece with the slot on the
breath pipe.
Operation:
Read these instructions before consuming alcohol.
WAIT! 20 minutes after drinking alcohol before taking a reading. If you don't wait, the reading will measure
alcohol in the mouth, which does not accurately show your blood alcohol level.
1. Press the ON/OFF Power switch. WAIT! The detector will start to countdown from 200 to 000 on the display
window. This warm up process prepares the sensor and circuit for testing. When you hear a BEEP and the green
READY light comes on, go to step 2.
2. Take a deep breath, then blow steadily and continuously (at least 5 seconds) into the pipe until you hear
another BEEP. Your lips should be sealed around the mouthpiece while blowing. Be careful not to cover the
Breath out opening on the unit. (If you don't blow within 30 seconds, the unit automatically displays "OFF" and
will turn off.) After the red and green display lights blink for 4 seconds, the test result will be displayed for 15
seconds. This is your Blood Alcohol Concentration, or BAC. Finally, the unit shows "OFF" for turn-off, along the
BEEP sound. Press the ON/Off power switch to turn unit off.
If your blood alcohol concentration is:
Below 0.01%
0.01 to 0.04%
0.05% or Over
0.40% or Over
If you drank very little
The reading will be
The Red WARN LED
Display will read "Hot"
alcohol, your actual
displayed.
will flash along with a
and the Red WARN LED
concentration may be below
"BEEP" sound. Your
will flash along with
0.01 %, and the reading may
ability to drive may be
"BEEP" sound.
not be activated. However,
impaired. Don't drink
the display shows 0.00%
and drive!
and you're in the safe range.
For subsequent testing, repeat steps 1-2.
Space tests at least 2 minutes apart.