Direct Healthcare Group Bure Rise & Go Manual do utilizador - Página 9
Procurar online ou descarregar pdf Manual do utilizador para Produtos de higiene pessoal Direct Healthcare Group Bure Rise & Go. Direct Healthcare Group Bure Rise & Go 12 páginas.
Também para Direct Healthcare Group Bure Rise & Go: Manual técnico (12 páginas)
Imprimir página
Castors/brakes
Castors roll easily/tread not damaged.
The castors are tightly fastened to the lower frame.
Castor brakes functional on all castors.
Handbrake functional.
Harness
Belts, seams and Velcro fasteners are whole/intact.
The walker lockplate (green) is functional.
Holder, belts
Holder, belts not bent (see Figure s3).
Harness and attachment belts must be replaced
every three years.
12. General maintenance advice
•
Before use, check that the holder and belts are not bent (see Figure s3).
•
Before use, check that the harness is not more than 3 years old (see labeling).
•
Wipe the walker and its armrests clean as necessary; use soap solution/surface disinfectant.
•
The product can be washed in washer/machine or similar since electronic components are sealed to IP65
classification. Please note that the product is not made out of stainless material – frequent use of water/
detergents may therefore shorten the life of the product.
•
Replace damaged parts immediately; must be done by experienced personnel.
•
The product is only intended for indoor use.
13. Technical specifications
Dimensions apply to walkers with 125 mm castors.
Part No.
Product
width
56-316
77cm
U SER MA N U A L
Max user
Length
weight
150kg
89cm
D IRE CTHEALTH C A RE GR OU P.C OM
Clean or replace castors (NOTE: Castors are
always fixed to the lower frame with thread locker
or lock nuts. The castors are sealed and we do not
recommend their dismantling; instead, replace the
whole castor assembly.
Tighten the castor bolt and fit locking nut or use
thread locker (depends on model).
Replace castor assembly.
Adjust the brake or fit new castors.
Replace harness. Available in three sizes (S, M, & L)
Replace lockplate
A bent holder is a sign that the product has been
overloaded. The frame must be replaced before
further use.
The action is then "Check harness labeling. If the
harness production date is older than 3 years, the
harness and belts must be scrapped.
Height
Weight
96-136cm
25kg
Armrest/
Internal
dimension
34-65cm
9