3Com REMOTE ACCESS SYSTEM 150 Nota de lançamento - Página 6

Procurar online ou descarregar pdf Nota de lançamento para Hardware de rede 3Com REMOTE ACCESS SYSTEM 150. 3Com REMOTE ACCESS SYSTEM 150 10 páginas. Superstack ii remote access system 1500

Imprimir página
6
R
N
S
ELEASE
OTES
UPER
Extra Blank Faceplate
Packed with the PAU
PAU Delete Command
set imodem interface
command in the CLI
for the PAU
Restoring Router Unit
to Factory Defaults
S
® II R
A
S
TACK
EMOTE
CCESS
Table 1 Event Viewer Messages
Message ID
Message
1
Security Service installed successfully
2
Security Service disabled
3
Security Service enabled successfully
with encryption key (key)
4
Security Service stopped
5
User successfully authenticated user
RAS 1500 IP Address
6
User failed to authenticate user
RAS 1500 IP Address
For this release of the software, an I/O card does not have to be present in
the Router Unit (however, if one is installed it must be installed in
rm0/slot:1). Although you do not have to install an I/O card in the Router
Unit, it is recommended that you cover the blank slot so that no slots are
left exposed. An extra face plate is provided when you purchase a PAU.
This face plate should be used to cover this empty slot in your Router
Unit. It can be easily attached to the unit by using the panel screws that
are provided.
Remove the STACKNET cable from the PAU before issuing a delete
command.
There is an undocumented
modem configurations on the PAU that is not displayed in the section
entitled, "Set Commands" in Chapter 4 of the SuperStack
Access System 1500 System Reference Guide. Enter the following
command to save your PAU modem configuration:
set imodem interface <PAU interface name> at at&S
When the Router Unit is restored to factory defaults, the IP address and
manage user(s) will be deleted. To begin using your RAS 1500, you must
reassign an IP address, either through the IP Wizard available from the 2.0
Resource CD if you are a PC user, or through the CLI Quick Setup if you
are a UNIX user. Refer to the SuperStack
Quick Setup Guide for details on setting an IP address for your RAS 1500.
1500 R
2.0
YSTEM
ELEASE
set imodem interface
®
command for saving
®
II Remote
II Remote Access System 1500