Xerox WorkCentre 7300 Series Manual de resolução de problemas - Página 15
Procurar online ou descarregar pdf Manual de resolução de problemas para Impressora Xerox WorkCentre 7300 Series. Xerox WorkCentre 7300 Series 40 páginas. Xerox printer guide 7300
Imprimir página
Review the five test pages printed with this page: The pages consist of cyan, yellow, magenta, and black; and another
page with all four colors. Use the information below to help solve your print-quality problems.
Note:
The examples shown are Long-Edge Feed (LEF). If you print Short-Edge Feed (SEF), the examples below are
rotated 90 degrees. The images shown are for reference only. Not all pages represented are printed.
Problem
Light Lines in One Color
Thin, light or white lines appear in only one color.
Dark Lines in One Color
Thin, dark lines appear in only one color when
a light color is faded or blended with black.
Printing Is Too Light or
Too Dark in All Colors
Page 1 of 3
PHASER
®
7300 COLOR PRINTER
Solution
1.
Open the top cover.
a.
Clean the four LED bars (a) using
the cleaning pad supplied with
each new toner cartridge.
b.
Check the Imaging Unit and re-
move any foreign material if found.
Caution:
Do not leave the top cover open for more than 10 minutes
without covering the Imaging Unit as damage could result. Use the
dark bag that came with the Imaging Unit or dark paper as a cover.
2.
If the problem persists after cleaning the LED bars,
do the following:
a.
Check the toner for the problem color. Replace the
toner if low.
b.
Lift out the Imaging Unit, for the problem color, keeping
the toner cartridge installed.
c.
With the Imaging Unit in an upright
position (to avoid toner spills), lift it
high enough to visually inspect the
shiny green surface underneath.
d.
If the shiny green surface has scratches or damage that
align with the defect of the print, replace the Imaging Unit.
Note:
Some slight scratching is normal.
Caution:
Do not touch the shiny green surface of the Imaging Unit.
Set the Imaging Unit on a hard flat surface only as scratching or
damage can occur causing more print-quality problems.
1.
Try a different Color Matching mode. From the printer's front
panel
Support Menu
select
Print-Quality Tips Page
Note:
The
TekColor Correction
the best results for most documents.
2.
Adjust the light or darkness levels. From the printer's front
panel
Support
Menu, select
select
Calibrate Colors
Page. Follow the procedure Lighten/Darken Colors.
Diagnosing Print Quality
a
select
Improve Print
Quality?, then
and press OK.
set to
Automatic
Improve Print Quality?
Menu, then select
Print Tutorial
provides
then