Calex PUA8-CF-WJ-5M Manual do operador - Página 13

Procurar online ou descarregar pdf Manual do operador para Termómetro Calex PUA8-CF-WJ-5M. Calex PUA8-CF-WJ-5M 17 páginas.

DEFAULT SETTINGS

Modbus Slave Address

Emissivity Setting

Reflected Energy Compensation

Window Transmissivity

4-20 mA Output Scale

Hold Mode

Hold Period

Average Period

Once the sensor is in position and the appropriate power, air, water, and cable connections

are secure, the system is ready for continuous operation by completing the following simple

steps:

Turn on the power supply (not required if connected by USB only)

Turn on the instrument or PC

Read / monitor the temperature

IMPORTANT

Be aware of the following when using the sensor:

•

If the sensor is exposed to significant changes in ambient temperature (hot to cold,

or cold to hot), allow 20 minutes for the temperature to stabilise before taking or

recording measurements.

•

Do not operate the sensor near large electromagnetic fields (e.g. around arc welders

or induction heaters).

•

Electromagnetic interference can cause measurement errors.

•

Wire must be connected only to the appropriate terminals.

•

Do not open the sensor housing. This will damage the sensor and invalidate the

warranty.

Our customer service representatives are available for application assistance, calibration,

repair, and solutions to specific problems. Contact our Service Department before returning

any equipment. In many cases, problems can be solved over the telephone.

If the sensor is not performing as it should, see TROUBLESHOOTING and try to match the

symptom to the problem. If the table does not help, call Calex for further advice.

Keep the lens clean at all times. Any foreign matter on the lens would affect measurement

accuracy. Blow off loose particles (if not using the air purge accessory) with an air 'puffer'.

0.95

Off

Full temperature range, depending on model

Off