Direct power DPB053STM Manual de Segurança e Operação - Página 10

Procurar online ou descarregar pdf Manual de Segurança e Operação para Ferramenta eléctrica Direct power DPB053STM. Direct power DPB053STM 17 páginas. 2000w wallpaper stripper

Imprimir página
Fig 5
TWS200-M-070924.indd 10
dry.
You must always work in a well ventilated area
and if you feel unwell due to the heat immediately
switch off and unplug the steamer and take a
break from the work until you feel better
4. Refilling the water tank while wallpaper
stripping
Should the need arise to refill the water tank with
water while wallpaper stripping:
1. Switch Off and unplug the power cable from
the mains supply socket.
Warning: Although the steam pressure in
the water tank has been released, the water
tank still contains very hot water. Do not attempt
to remove the safety cap until the water tank has
cooled down.
2. Wait at least 5 minutes for the water tank to
cool, then carefully start to unscrew the safety
cap. If you hear steam escaping, stop and wait
until the hissing sound stops.(Fig 5)
3. Carefully, continue to unscrew the safety
cap. If you hear steam escaping from the cap
immediately stop and allow a further 10 minutes
cooling before attempting to open.
4. Continue in this manner until the safety cap
can be removed. Take great care, as any residual
water is very hot.
5. Slowly fill the water tank with water using a
funnel..
6. Screw the safety cap back onto the steamer
and tighten by hand.
7 . Plug the 3-pin mains plug into the mains socket
and switch on.
8. Continue with the instructions for switching
on.
9. When you have finished steam cleaning, switch
off and unplug the power cable from the mains
supply socket.
10. Allow the water tank and all accessories to
cool completely then empty any residual water.
Clean and dry the accessories and store in a dry
place.

SAFETY CUT-OUT

A safety cut-out is fitted to prevent overheating
of the element if the water boils low. If the water
2007-9-25 15:45:03