Xerox WorkCentre Pro 123 Manual da rede - Página 3

Quick Network Setup Guide

This guide includes instructions for:

■

Quick Network Setup (DHCP)

Quick Network Setup (Static IP)

■

Quick Network Setup (DHCP)

The System Administrator Guide contains detailed information about network setups. This document is

intended for setting up the network using TCP/IP. If using Novel IPX, see the System Administrator Guide

for setup procedures.

Prerequisites for Quick Network Setup Using TCP/IP

Confirm that an existing operational network utilizing TCP/IP is available.

Confirm that the Ethernet cable is plugged into the multifunction device and into an operational Ethernet

port on the network.

Note

The Ethernet cable is an RJ45 type and is not supplied by Xerox.

Configuring an IP Address via DHCP

On startup, the multifunction device defaults to DHCP to obtain its network configurations. A DHCP server

delivers an IP address, as well as other configuration settings to the device. If you use a DHCP server to

allocate an IP address to the device, then proceed as follows:

Procedure for Quick Network Setup Using TCP/IP

Power on the device.

Wait a minute or so while the device negotiates an IP address.

Print the System Settings List.

Select the Machine Status button on the device.

Select

Print Report

Print Mode

Select

Setting List - Common

Press the Start button.

on page 1

on page 3

List.

Settings.

Items.

Xerox WorkCentre

M123/M128/133

Pro 123/128/133