Xerox SquareFold Trimmer Module Manual do utilizador - Página 18
Procurar online ou descarregar pdf Manual do utilizador para Acessórios para impressoras Xerox SquareFold Trimmer Module. Xerox SquareFold Trimmer Module 24 páginas. Xerox printer accessories user guide
Também para Xerox SquareFold Trimmer Module: Manual do utilizador (28 páginas)
Imprimir página
Problem solving
Fault Codes
Fault code
E100
Jam/fault with the SquareFold Trimmer
E101
Module
E102
E103
E104
E105
E106
E915
E916
E917
E918
E919
14
Possible cause
If a jam/fault occurs in the SquareFold Trimmer Module, a
fault code is displayed on the Control Panel. The machine's
UI may also display a jam/fault message. The following
table provides a list of fault codes for the SquareFold
Trimmer Module and also provides a list of related finisher
fault codes.
Important!: The top covers cannot be opened during normal
operation or when the machine is idle. The covers can be
opened only when an indicator is lit (refer to page 4) and a
jam/fault occurs within the SquareFold Trimmer Module.
Recommended solution
1.
Open the Top Left and Right Covers of the SquareFold
Trimmer Module.
Carefully remove all sheets and paper scraps from jam
2.
clearance areas.
Close the SquareFold Trimmer Module Top Left and Right
3.
Covers.
4.
Check the Trimmer Waste Container:
•
If full, empty the container and reinsert it
into the SquareFold Trimmer Module.
•
If the container is partially pulled out, push
it completely in.
5.
If necessary, follow any remaining instructions on the
machine's UI.
If fault persists, repeat Steps 1-5; if fault persists after that,
6.
call for service.
SquareFold Trimmer User Guide